The Jalopy Journal
Here's what I have going on. I have a 74 351W in a 52 ford. It recently started hesitating alot under a load going through the gears. I replaced...
What did you use to Polish to get metal to come out looking like that ???
yah..rough crowd.. Not that it will sway me from doing what I'm doing. Thanks for the advice . I appreciate it. Just ordered some Gibbs , I...
I'm in the final stages of my baremetal Lincoln. My question is for anyone who has done this. What did you do to get all the swirls and blemishes...
Does any one have a good Door popper company they they would recommend ? Shaving the the handles on 52 4 door lincoln. Thanks Yall.
Trying to figure out who makes this tire I have on my car so I can match it up. Its got a giant bulge in the sidewall so I need to replace it....
Can anyone tell me if they make and where I can find chrome bullet style dust caps. . Not big 4 inch ones that go over my entire hub... just ones...
Yes...it was good before lowering.
[ATTACH]
I just put in 4inch blocks in the rear end of my 52 Lincoln.. sits pretty damn low.. pretty happy with the stance. I took it around the corner...
Thats a good idea Squablow..... i didnt think of doing it that way. Thanks.
[ATTACH] [ATTACH]
I just got some chrome bullet style dust caps from united pacific for my 52 Lincoln. There is a threaded bolt and nut that comes with it obviously...
After blowing up my origjnal 194 ..I recently picked up a 207ci out of a 33 Chevy for my 31 . Looks like for the most part things will match up...
I recently spun a crankshaft bearing on my 31 chevy which in turn through my crank into a wobble and smacked into my cam and took a big chuck out...
1963 Ford F100 Unibody. 223 Cubic. 3 spd on the tree. This truck runs like a top. Brand new points , starter relay , coil , cap , ignition switch....
Alright.... cool.. I'll check into pricing out some dropped axles ... and taking some leafs out of the front... 2 leafs max ?
Wanting to lower my 63 f100 ,but I don't want to slam her all the way to the ground , at least just not yet. I want to have her pretty low though....
Alright .... I'll Check that pigtail tomorrow morning .... Thanks again
I got her running !!! Honestly I wish I could tell you exactly what I did to fix the problem. .. But I did Take a little emry cloth to those new...
Yep....power to the coil and out of it. 11.8 volts. The rotor is spinning when cranking just fine.... I checked the ground wire from the dist. To...
Hey yall.... I've been racking my brain now for a couple of weeks why my 63 Ford with a 223 6 cyl is getting no spark.... now I'm at my wits end....
Hello from the FNG..... names Van. New to the Hamb.... I look forward to sharing and soaking up knowledge with fellow gearheads.... The Rods I...
Separate names with a comma.