The Jalopy Journal
[IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] Part Number SB1625-1 (Valve Seats) Specifications Type Data Angle 45...
all of the seat i have done the cutter was a common size 1.5 1.625 1.687 ect and the seats had the press built into them. for your 1.625 bore the...
Newer than 1965 but thats only a guess
I moved the 350 in my 50 chevy truck 1 1/4 to clear and never noticed
pull it apart and weld it up looks to me like some cut a bushing out wit a torch and burnt through. you might have to grind it bigger to weld it...
I would have to reread his post again but i believe he added a hole for clutch adjustment and that was where it failed
The wire is to energize the altenator as soon as you turn the key with out it it has to spinn fast enough to energize its self. If you car starts...
was a common failure on hei distridutors when the wires from the pickup to the modual
EFI is not shown here and what updated suspension most independants will not be welcome. Looks like you have a cool project if the efi is the only...
The blocks i have seen bushed on 1 side had a 0.030 oil feed hole drilled to feed a solid roller setup. Are the bushings honed to size because...
Looks like b&m is part of holley now call there tech they are good but you might be on hold for a while 1-866-464-6553
https://www.jalopyjournal.com/forum/threads/hemi-dodge-truck-bell-housing-flywheel-linkage-dust-cover-etc.1210546/ If you are looking for a stick...
the truck bell works with the smallblock tranmission length. the fe car trans used a shorter input shaft.
Where are you mich is rather large
This is the other side of sellers not putting a price on things and asking the buyer what will you give me
Whats with the welded pitman arm is it still the stock length if it was shortened it will take more effort to turn the wheels
Have you red the replies? To sum it up you dont belong here and you are dumb for doing what you are doing is the main idea
Two questions why 0.080 and what was a cj 390
A 302 boss is a windsor block with large port heads. I am pretty sure the boss block was originaly cast for the tunnel port trams am racing...
The list is very long but lets point out this one that 3 years to new
lg small block is too new also but i cant count them all
all of them i have seen have a gasket on bolth sides of the shim
the marine carbs i played with had the none adjustable fuel needle so the bowl would be differnt. you can still get parts from holley they will...
post 3 more times and you will not have a problem. the rule is to keep down scammers
the pony car we speek not of had 10x1 3/4 rears from 65 to 67 ish then 10x2 and wider untill 73 so you should be able to find any part aftermarket
[MEDIA] did this to lots of blocks heads and even some cranks but they where getting ground
we had an ampro cleaning system back at 500 blast in its airless blaster for 10 min with stainless shot then tumble to remove any shot. worked...
Sorry if i want to watch youtube i will go there
the one with the lj small block and air bags
looking at the face of the pulley and the crank snout putting a little heat in that crank will be the least of your worries. it looks like your...
Separate names with a comma.