The Jalopy Journal
is this going to be an issue? so when you run an external resister you can bypass the resister when starting, with an internal you dont have that...
i'll go with a stick welder as well, just an ac one is fine, easy to see a puddle, takes some skill to get an arc started and run a nice even...
try them out before sending them anywhere, if they have O-rings make sure they are good or replace them.
I open cans all the time for marbles, some are almost new and just wont spray, i guess after doing maybe 100 I have it figured out, i lay the can...
how do I tell if I can bore my 283 out to 4"
would a stock 28 chevy blow the doors off a 28 model-A?
looking great Ron, I need to come for a vist
I say buy a gas welder, I saw a nice little miller mig at a swap meet for $200 a month or so ago, I have 5 millers now, two migs, two sticks and a...
anyone know what type of steel is used, 4140?
looking great, need to keep track of this build
nice work, one set at a time
sorry i do not have any pics of mine, it was two pieces of 8" flue pipe about 4 ft long joined with flex pipe, the arms that the tubes were...
i have built a few dust collectors in the past, i used a squirrel cage blower inside a sheet metal box, there is an opening for the air to exit...
you may have posted this a few years ago but what will your top speed be?
so after you drill the holes you can close the butterflies so only the idle hole shows is what i'm getting, also as i recall on engines with EGR...
i like this video, and no i have never even touched a 32 ford, chevy yes. https://www.youtube.com/watch?v=gmV4qwLfOMY
ok so they are uni-lugs, i have used the ones with oval washers that sit into an oval hole, i have used the ones with a round washer that sits in...
from the picture i'm not sure they are uni-lugs, maybe it's the angle of the shot, i don't see a place for the washer to sit down in.
thanks squirrel, i guess i'll go with the 3.08s, there is a little rust on one axle gear, can i change just that one gear or should i change both...
i just pulled another one apart, it is a 3:08 i guess. i'll look for the casting marks on all of them, i have one more i can pull apart but will i...
Hello friends, about 4 years ago my 45 GMC was hit by a distracted driver who came into my lane and struck my truck in the drivers rear fender and...
i have asked a question about how to mark a new dipstick in the past, if you could see inside an oil pan how far below the crank should the oil...
this happens to me all the time, what makes it worse is i like to talk and tell stories.
i have had this happen because of rust in the fuel line, the rust gets pulled toward the engine and stops the fuel, then when the engine stops the...
if it were me i would not say i'm heading the the muffler shop, thats a little like an admission of guilt, just ask if the cop think it is too...
red is my vote, next month it will be 4 years i have followed this thread.
you could use it to mill press brake tooling
open it up and show us the inside please.
will you sand and polish it now?
my understanding is the roof at the A pillar is the same height for a 5 window and a 4 door, but the B pillar is 3/4" taller, having talked to a...
Separate names with a comma.