The Jalopy Journal
pull the trans and repair it. A different shifter will not fix the problem
the max you can go is 10/1. You need rpm and heat not much idle time. A shot of octane booster in every second tank of fuel will help.
It sounds like if you have to ask you do not have the skill to do it.If your talking about the original cast iron xhaust manifolds you are...
I thought I should contact you through here rather than a phone call. I would like to pm you. Larry from black creek
solder it
Is the frame level on both sides before you install the engine?
Any welding method done correctly will work.
Drain the oil from the diff. If it looks metallic and silvery check for big chunks of metal. It probably needs to be overhauled. These things are...
As what has been stated above with a carbed engine you need volume not pressure. I most cases 4-5psi with a good pump will do the job.
I might have my cock out a mile here but I think the only vaccum line on a th350 goes to the modulator valve on the right rear of the trans. The...
It can not absorb air if it is in an air free environment. Somebody is going to jump on my dick but if the installation is done properly with...
Take the copper washers and heat them red hot and quench in water. This will anneal the copper and it will become soft enough to seal. I am sure...
I would say the pressure is too high. Not good will let the oil fiter bypass when oil is cold. High oil pressure also robs hp. I would use a...
That engine should start and run with those compression readings.If the engine is turning over fast enough and you have verified that the valve...
I am sneaking up on 71. Building an off road racing cj jeep with my grandson and in the process of building my own 36 chev coupe.
use an internally resisted coil and your good to go.
Bite the bullet get an msd igntion , install it and drive for miles and miles trouble free.
Generators do not charge at low rpm. You need at least 14.4 volts to keep your battery charged. This is the main reason alternators replaced the...
Back the brakes off and heat the portion of the drum between the axle flange and the wheel studs. You will probably here some noise as it expands....
Its time to pull the valve covers and check some numbers. Check the block castings nos also. I am thinking 283cid. The numbers will tell you the...
I do not want to step out of line here being a newcomer but in my opinion holley carbs are great on the drag strip but piss poor on the street. I...
ok guys you have got an old opinioated guy that just registered. I am a red necked canuck that lives in black creek on vancouver island in the...
Separate names with a comma.
The Jalopy Journal