The Jalopy Journal
Thank you Mike! Looks good all the changes you did to the clutch system.
Yes the down rod is long one. What year is that off?
Hey Mike I don’t see the link. Can you try and post it again please. Thank you!
Thanks for the tip! I was hoping to hear something like this
Yeah it broke at the 90 inside the cab. Not sure if I lost any other parts off the bell crank but I guess I’ll find out. Thanks for the reply.
Hey all. I recently broke my clutch down rod on my 1965 F100 and of course it’s the year that isn’t reproduced. My question is does anyone know...
That was it!! Thanks, I honestly had no idea that dimmer switch was even there.... kinda odd but it still works. Thanks again!!
PTO... Thank you very much for the response and the message. I will give that a shot and let you know of the outcome! Thanks again.
Hey everyone I have a 1958 Edsel Pacer and recently I noticed that the dash lights are not bright anymore, including the aftermarket temp gauge...
I will try to answer all questions here. So when I first got it I used an oil flush and have since chnged the oil a few times. I have ulled the...
Ya it doesnt have adjustable rockers i have already checked to make sure i dont have any bend pushrods or any valve train items loose. I will try...
10-4. I usually run mid grade but it does have 10.5:1 from the factory so premium may be required and lead substitute?
I have it set at around 8 or 10 now and the vacuum is on the bottom but i cant remember if its on idle vacuum or load vacuum port. I would want...
What would be a good timing for my 361?? Also, which port should my vacuum advance be on? Its an edelbrock 600 cfm fyi.
Its funny you mentioned that because it will make a sound ike a bearing is sqeeling every once in a while and it comes from down below. I guess my...
Yes it does actually but would too advanced timing only cause it after it gets warmed up? Ill check the plugs either tonight or tomorrow. Thanks!!
Well here I am again posting another questions about my Edsel. It's a 1958 Edsel with the FE 361, recently replaced radiator and hooked up a temp...
A two row radiator sounds a little small for a 390 honestly but that's just my opinion. I have a 3 row aluminum radiator in my 58 Edsel with a 361...
I have a 58 Pacer 2-door and I am pretty sure the lug pattern is 5 x 4.5"
Ok cool I am going to try to slip a rubber hose over the entire bypass tube and hook it to the water pump. If it doesn't work then I will be have...
Thanks for the reply. I would rather avoid pulling the intake off so can this be pulled with channel locks or some sort of garage tool? And does...
Bump
Also, If I were to replace the intake manifold will any year FE intake work on the 361??
Well I got a new radiator today and was in the process of hooking up the temp sending unit to the top bypass port from the water pump to the...
Ok thanks John! Ill do some research and see if anyone has those pumps
They said they coud send it out dor rebuild but may take a bit of time and not sure of the cost
Hey everyone i just found out through a local parts store that my edsels water pump is discontinued, this true? What do i do when i need one? I...
Well the bendix gear or starter gear went on my 1958 edsel Pacer with the 361 so I was curious if anyone has a picture break down of the gear...
Welcome from Southern California. I own a 1958 Edsel Pacer 2 door. I am still learning about the car but if I can help at all let me know!
Now whats weird is that the only time that my car makes the "noise" is after I have been driving it and its nice and warm. Does this make it...
Separate names with a comma.