The Jalopy Journal
I dealt with a similar issue. The output seal fit the yoke but the bushing was too large. It didn't leak but vibrated only at certain speeds....
I'm currently running a torker on my 58 jeep pickup with 350 block, double hump heads, mildly aggressive cam, m20 trans, and 4.88 gear. Pulls...
I've had great results sanding sidewalls with 80 grit on a da. Then go over the whole sidewall with 320 to give it a consistent finish. Sent...
I feel like the smaller displacement versions of any engine family seem to run the best. 283/327 chev, 290 Amc, 232 Amc 6, 330 olds, 260 ford...
Why not try something different? They're just tires and can be easily swapped. How about some bandag gripper treads on a whitewall casing? I...
How does a right rear wheel pass me on the left side when the studs fail? I vote no on spacers. Posted using the Full Custom H.A.M.B. App!
Ha! Had this happen to me today. The spade connectors in the distributor had lost their tension. Third module in a short period of time. I...
Out of all the things to check, what prompted you to pull the pcv out of the valve cover? It's not even in my top 100. I would start with fuel...
I also agree with the polish/new bearing thing, but don't overlook the cam bearings. I've been bitten a few times with low oil pressure from worn...
So many things to check so I'll throw out a few. Are the plugs wet with gas? That would verify your getting fuel. Does it have compression?...
I have some New Britain tools from my father. I always liked them because he grew up in New Britain (CT) and my grandfather worked at new...
The number stamped into the axle tube is the Dana bill of materials number. The listing is available online and will tell all about this axle...
I've worked in a tire store for 35 years. The white rubber is thick enough to endure some careful buffing to expose some clean white rubber. I've...
Separate names with a comma.