The Jalopy Journal
Nice!
The mounting for the brake and clutch bracket was a little too wide against the bell housing. If I recall, I also had to massage it emergency...
Thanks for the well wishes guys.
She's in. I just need to install the rebuilt trans tower and synchronize the 81's. Then we'll see what other gremlins emerge.
Here is the pic I promised.
Here is my repro dropped headlight bar. It goes with the look I am going for "the Gentlemen".
Subscribed
Does anyone make a fan to attach to the v8 water pump conversion?
If I recall, Larry sold the A intact.
Before I bought it, Larry sent it out to be disassembled checked out, and reassembled. He was also able to get it running on his own engine stand....
Here's a update to this thread. I bought the engine from Larry about two years ago. It is FINALLY, running and driving after over 50...
To make a long story LONGER: The engine, as I was told, was built in Idaho to run on the salt flats. It was built in the late 50's and set in a...
I'm looking forward to tomorrow morning. TJ from throttle jockey originals just finished some fabrication and assembly for me. I now have a...
Thanks to all. I bought a rear set from Pure Hot Rods and a set of shocks from Kenny's on eBay. I'll post spot. Thanks again!
Please pm me with price. Thanks.
I'm looking to buy a rear shock conversion for a traditional build. If you know of any vendors, or have any experience you would like to share,...
Try spraying Eastwood Pre on a rag and wiping it lightly until you knock down the sheen. Posted using the Full Custom H.A.M.B. App!
Great Video. Number 620 Norm Hutton? Was that the Silver City Special built by Mark Phelan (Gen Gow)? I bought it from Mark, did some work to...
It sprays oil onto the crankshaft at higher speeds. I'm not sure if it's hooked up. The engine was build to run on the salt flats in the late 50's.
Thanks guys. After some grinding and drilling, I think the kit will work. I figured I would do all the fitup while the engine and trans are...
I purchased the A to B conversion from Burt's. It does not seem like anything is lining up. 1) pics of trans below - is this a B trans? 2) pic...
do you have a "straight on" pic you could share to see what it should look like?
I love the look of the dropped headlights. Are there any resources on how to do it yourself or is it better left to the professionals?
Damn, I have a lot of reading to do...subscribed.
Damn it's March already! Do we have a March thread? Got to get back to those tax returns....they're not going to prepare themselves. March...
subscribed
Thank you SoCal, I am using the 32 perches with '32 cross shaft. All lines up except the brake rods. I was looking for someone who has made...
thanks G. I already sold the complete '31 front end and invested quite a bit into the '32 parts I already have installed. It looks like a little...
Do you have any close-up pics of the brake actuators and the levers? My email is [email protected] Thanks So-cal Tex
I took it one step further and used the 32 brake actuators along with the 32 perches, axle and kingpins. Anyone have any comments or pics how...
Separate names with a comma.