The Jalopy Journal
I had plenty of people say it wouldn't work or I wouldn't be happy with it but I have a Weiand tunnel ram and two 450 holleys on an old 350 pulled...
After a couple years of running this setup I thought I add to the thread for anyone reading this later. The reason for building this truck was...
It would depend on the type of rod ends you have on the drag link but I have a very similar setup and it was doing the same thing I just put the...
I have a weiand tunnel ram on my sbc the HEI wouldn't fit but I believe any if the smaller ones without the coil on top will fit you should be...
I appreciate the concern but why did this turn into a thread about why I shouldn't use a tunnel ram? there is already lots of those and I've read...
smartass I know the picture doesn't help I'm just trying to get some support on why I'm doing this I'm using the groove that I put in the...
Here's a picture to help
I'm assuming I can't actually go to 28* at idle as dirtracer06 mentioned I could have starting problems any idea how far I can go before that's a...
we are all over but making progress the first problem was the balancer it had a timing mark for a pointer at 12:00 got a new pointer made anew...
max vacuum puts the initial around 25-30 which would put total well over 40 how much total can I have (with vacuum advance unhooked) most of what...
Ok guys if I set the timing using a vacuum gauge it wants a lot I've read tunnel rams like a little more anyway has anyone had experience with...
Mine was doing this too check and make sure the switch can handle the amperage mine was good there but I seemed to have a problem the way things...
Ok thanks for all the help guys I've got it running better now all of the floats were too high and I've got the timing close one more question I...
Still battling this the best I can tell my new timing mark for TDC is pretty close even after checking a couple of times timing still way advanced...
It is a Pertronix Flamethrower distributor and Flamethrower II coil
I'm using a sears timing light that is older than I am no dial or anything on it so I think I'm ok there, vacuum advance is unhooked. I know there...
it ran fine before with a single carb and HEI distributor but I have no idea where the timing was it ran when I got it and never changed it then I...
Ok so I got a new distributor and coil and thought I had things in place and fired up the motor it started and actually sounded pretty good but...
Thanks for all the info so far I'd have to buy a used distributor, pertronix kit, and new cap would cost as much as a ready to run distributor...
Well I finally got the carbs rebuilt for my weiand tunnel ram and went too install it everything was looking good till I went to put my GM HEI...
It's basically a long hinge that mounts on the cowl and the radiator support Posted using the Full Custom H.A.M.B. App!
[ATTACH] This will be going on my 46 soon Posted using the Full Custom H.A.M.B. App!
I get a lot of "what is it?" Or "where's the hood?" But my favorite is " you didn't actually drive that here did you?" Posted using the Full...
[ATTACH] Posted from the TJJ App for iPhone & iPad
Details on the truck...started witha 46 chevy 3/4 ton chopped 5 inches channeled 2 put on a different frame with a chevy 350 and a four speed and...
I've been working on a 46 chevy truck for the past few years and over that time have used this forum for all sorts of information and finally...
Separate names with a comma.