The Jalopy Journal
Guess my truck will be traditional in another 20 years :(
I am a land surveyor here in south central Tx , and I have a great need for good batteries to run my equipment . I typically use marine deep cycle...
Didn't want to start a new thread . I have a question might b dumb but I don't know the answer . Can I put a camshaft with some bump if I running...
Funk n
Who's goin to the "Day Of The Drags" at the prettiest dragway in TX Little River Dragway Oct 4th & 5th 2013 ...
Do it !!
I have had to pull over because it felt like I was pulling a trailer house , the brakes were stuck so bad !! Guess ill break down and get a...
I also checked out the calipers and they all seem fine !
I did the crown vic ifs swap and I also put a 99 exploder disk brake rear in the truck . I've have had the truck up and going for awhile with no...
Yeah in town it's sweet ! Ill probably just suck it up and drive the shit out of it , I know it's a lot better than the three speed I had .....
The rims aren't hamb friendly but it my truck and I like them . I am use to cruisin at 17-18 hundred Rpms down the highway in my daily , my dad...
66 f100 The first gear ratio is 3.97 ,the tag on the tranny is 1352-209 which is a 91-92 4cyl ford t5 . The rims on back are 17x11 with a 315/35/17
Yeah my current gears are 3.73 . I've used the calculator and 3.00 looks like what I want , but I was looking for someone with real world...
I have a bone stock 300i6 bolted to a 4cyl mustang t5 and 3.73 gears in a 8.8 . Cruisin on the highway at 65 according to my calculations I'm...
Put some nitrile rubber gloveson get your hands to sweat real good take them off and wash them real good . Works everytime
Thanks for the info fellas . I'm fairly new to using torches so yeah lots of practice is in my future .. When I bought the set I obviously knew...
Was wondering if any of you guys are proficient with torches ? I need some advice about different size tips and such , I wanna be able to cut...
I installed a 04 crown vic in 66 short bed . As for being to wide I would disagree you just have to run the right offset wheel .. Rides like a...
I put a pertronix on my 300 i6 and have been really happy ...
I will Definetly look into those two thanks a lot guys .. Not really trying to go fast just want some bump if ya know what I mean ... :)
Looking for a cam for my 300 /6 . I'm in the austin tx area , if anyone knows of a legit place let me know thanks..
Trying to pull this thing out of my 66 f100 and can't get the speedo cable out of the trans ? Any secret to this thing .. ?
Thanks man
Sorry it originally had a 240ci now a 300 but I used stock tranny that was in it
66 f100 three on tree . Trying to figure out what tranny it has. Anyone have a idea? Thanks
Gear head / ill have to try that I was gonna take the sum bitch out . Moving it back Alittle makes sence..
I have a 66 with crown vic ifs . I put 05 mustang bullets on it , only problem I have is turning sharp the wheels hit the sway bar . Other than...
Well guys turns out my new "radiator" wasn't so new had it cleaned like a lot of you suggested and guess what ? Bitch runs cooler than the other...
I just diognosed the vacuum advance is bad does hold any pressure ! Ordered one should have it on tomorow . Ill keep y'all posted
I'm kinda keeping the head gasket in the back of my mind hoping that's not the problem . I kinda doubt it but you never know . I think there's a...
Separate names with a comma.