The Jalopy Journal
I know Mitsubishi industrial engines come in balanced and unbalanced designs. I am thinking they have two counter rotating shafts.
Thinking. Thanks for spending time with LSI. A lot of good input. Craig
Any updates from LSI?
I think that would be only one of the issues
Three Widows: If you would be using scrap aluminum, it must be cast, not structural, as cast aluminum contains silicon which allows it to flow...
3/8", 2 sets, will PM you. Thanks.
I would be in for a couple of the burnouts also for the block.
Regarding LSM, a good knowledgeable friend told me to check with them He says the cut their own blanks, quite an impressive operation.
Has anyone looked into these folks custom maching a camshaft? http://www.lsmeng.com/Camshafts.html
I have been following this thread for years, on and off. From 2010 until 2014, Dawford was quite active on this thread. I remember PMing him about...
Beck, as far as the lifter cover, why not make a ribbed pattern and have it sand cast? Hoping life has been good for you.
Price listed is for one cowl, price each. Vintage aluminum circle track sprint car cowls. Nice old units. They measure about 22" wide. $222.22...
SOLD
Old military belly tank. Don't know much about it. It is a shade over 10' long. About 21" at the largest diameter. I think it could have some...
Drtrcr, sorry, I did not read it correctly
Brian; I am putting a 3.7 in a Watson Indy car. I bought a starter off of Ebay from a shop in California. Number on the box is IMI 302-012. IMI...
Back up
Bump to the top. I am still able to get a set to the race this weekend, I will be leaving Ohio Wednesday afternoon of the 25th. Or, if you plan...
New production fiberglass nose and tail panels for the Watson Indy roadster. I have the molds and have a small shop hand lay these for me....
Just in is this Jones quick change midget rear, shifter. I pulled the one side cover off, I did not see and internal welds from a failure. There...
I recently went through this locomotive. I completely disassembled the entire unit and spent a lot of time correcting many issues. I installed a...
Nice Roper Whitney Magna bend. I am replacing this with a press brake, so it will be available in about 10 days. I need to bend a little bit of...
I have a large group of Ford v-8/60 engines I will be offering for sale soon, consider this advance notice. I have the makings of about 20 (+/-)...
For your consideration, a nice used Roper Whitney 48" box and pan brake. Model U416, 16 gauge mild steel. Bench mount, ready to work. I can quote...
SOLD, Thanks
Bump You need this
Separate names with a comma.