The Jalopy Journal
A few memories of Gerb. to start with, Casper. Road Angles club meetings and filling the Majestic theater with smoke. The seat belt campaign....
[IMG] [IMG] TR3 with GM 10 bolt rear end. Not H.A.M.B. friendly but is underslung. Greg Sent from my iPhone using H.A.M.B.
Just simply wonderful. Thank you. Greg Sent from my iPhone using H.A.M.B.
Great story and video. Is there any video with engine sound or did I miss it somewhere? Greg Sent from my iPhone using H.A.M.B.
Well this one wasn’t built with a VISA card and a Summit catalog. Good on you guys! Greg Sent from my iPhone using H.A.M.B.
My 3C IDA Weber’s do this. I pull the tops off and clean the orange sediment from the float bowls and it’s good till next time. Now that I have...
Yes. The finish is fluted and can be sanded out easily. The rotary table is used for a curved core. Sent from my iPhone using H.A.M.B.
Core box is split same as pattern. Use a ball end mill and cut most of the material out of the core half first. Then with a small amount of trig...
Ll Sent from my iPhone using H.A.M.B.
Joe Quick and dirty would be to wax the crap out of the filler tube threads and clean the cap with acetone. Mix epoxy and apply to the inside if...
Joe You need to determine what the thread lead is on the tank (threads per inch). Next you need to determine the diameter (actual) is of the...
Getting to where you can walk on it is one thing. Getting to where you can squat down to change a wheel takes a lot of self rehab. Just keep after...
I have both on my OT TR3. The polycarbonate is used for both the wind wings on the factory windshield and for the wind screens. I just unscrew...
I was at Camp Darby, Italy in the 60s and there was a pretty good auto shop there. There was a minimum rank requirement for private vehicle...
Late 50s and early 60s in fly over land. Cruising Lincoln Ave, Hebron NE Saturday night and later in trade school the Kings drive in circuit in...
Another 6
Cam was a concern when I did my motor. It occurred to me that reversion at high rpm to Jim Inglese is 8000 rpm. Looking at grinds it was apparent...
Ron, you are now headed in the right direction. Weber carbs can be tuned to any engine. I bought a Inglese manifold for my 231 Buick engine which...
Why not put 4 dcnf webers on this manifold and tune it as a true ir induction. Sent from my iPhone using The H.A.M.B. mobile app
Long range forecast is scattered showers in the AM and partly cloudy afternoon. 77 degrees. Sounds like roadster weather to me Sent from my...
A Buick V6 in a TR3 Triumph is a tight fit. I bought a bigger stock radiator to solve a heating problem. What worked was a aluminum cross flow. A...
The TR3 unit requires a straight open ended column. The unit is connected to a 3/8" id tube that is anchored to the end of the steering column...
The roadster owners usually say "coupes are for chickens" Greg
My Webers won't run without a phenolic plate. I have the 1/4 inch asbestos gaskets plus a full width 3/16" phenolic plate to stop heat rising...
post on the May banger thread. Greg
The two wings on the fixture need to be held in position with two angled screws through the center block. Remove the screws and the finished part...
Oh boy are you gonna have fun..... Greg
Stewart, these look similar to my TR3. My experience was the distance between the clutch and brake was not critical. The closeness of the clutch...
I really like your car. My TR3 had the same problem with the foot boxes. I have finally gotten things moved around so work boots fit but driving...
Separate names with a comma.