The Jalopy Journal
Where am I likely to get an 88-91 Chevy truck seat from? or even an original 55-59 Truck seat?
Hey Guys I've just recently bought a 58 Chevy Apache truck and it has 2 single seats in it. I want to get a bench, does anyone know of someone...
Kennet square to linden, it's a 58 Chevy Apache Yes i'm quite reasonable....
Hey Guys Not sure if this is allowed in this section...if it's not please delete. Anyone know any good car shippers from PA to NJ Thanks
What Bill said.... it's exactly the same housing just a thicker flange on the 2.56 differential.
It will take 3+ gears with a new differential and new gears to match....
I was thinking about that but I like the look of the gearvendors unit, you basically get an overdrive for every gear. Plus later on down the line...
The gear vendors won't be for awhile, the 4.10's would probably be a little too much for the time being wouldn't they?
I'm going to get a new posi carrier, ring and pinion and all new bearings. I don't do many highway driving in it only to car shows. The future...
Hey guys I have a 48 Chevy fleetline with a 350/350 combo in it, I have a 8.5" 10 bolt in the back with 2.56's open drive. I'm running a 28.88"...
Can anyone see that last picture?
I really don't know what i'm doing wrong then, I done what you said
[IMG]
Is that working now?[IMG]
Any reason why they wouldn't be working?
IMAG0055 by 49ChevTruck posted May 11, 2016 at 9:56 PM
Its a SBC 350 with 492 angle plug heads just to make things a bit more awkward! Are the photo's working?
Hey guys, I could do with some of help with my headers on my 48 Fleetline.... It has manifolds on it at the moment but at the end of this month...
Well I took the car out about an hour ago and I only really get it when I get up to about 50mph and i'm backing off the throttle....so not really...
Lippy thats a good point i've actually got a bolt missing out the hood ornament!
I'll check through it today and see if I can notice anything, I'll give you guys an update later on tonight. Thank everyone
I first set it up by hand pulling the cable with my wife in the car with throttle wide open. Since then I've used pliers to pull on the cable and...
Yes it sounds like it's from the engine, don't think it's a driveline issue I'll check it out tomorrow.
All the time i'm accelerating I don't get any noise just when I back off the throttle
Haha thank you dooley, I read an old thread on here and I noticed all the guys saying "you've wiped out a cam" guys
Got a 350 sbc in a 48 chevy and i've noticed over the past week or two i've got a tapping/ticking noise when i lift off the throttle when driving...
My lokar kickdown cable arrived today so I got it hooked up as the instructions.went out for a drive but still no kickdown...Any ideas?
Very good advice...it's starting up first crank of the key now so the new distributor has resolved everything. Just got a leaky fuel tank to sort...
I made sure the connectors were not pushing up into the cap last time I tried to start it, I changed the distributor this morning and it's fired...
I've got a ground to starter motor bolt from negative on battery then from block to battery. It was starting perfectly 2 days ago like this. I'm...
Separate names with a comma.