The Jalopy Journal
Hi David i have your dvd and watch it often . when you get to the bun panels could you document the build of them, i know your working on a tight...
Do you have any build pictures of the way you built the the body from the doors back? It looks great
royalshifter do you know the wheelbase on that modified ?
do you have prints for these ?
I have a b3 pnuematic and was wondering if you have a manual handle kit for it, sometimes its just to fast and what is the cost for a set of new...
thats a nice cleen job!
ps. use neversieze on the tap and on the ball joints
take a ball joint and grind the top off to remove the stud then cut two slots with a hacksaw 90 degrees apart in the threded section it will give...
very nice how did you do the layout and the outside bends
Now if you guys over at Baileigh could come up with a inner mandrel for wrinkle free bends we will have something !
i will be picking up a roadster body in austin tx in a 12 ft. box van and have some extra room. if anyone needs something transported along the...
very nice job!
dont waste your argon ! use a hose from the exhaust of a running car into the tank cut with plasma, grind disk ,sawzall ect.
raceway park swapmeet 28,29,30,
it looks like your shielding gas is not flowing right ,are you using co2 or argon co2 mix it could be as simple as a fan or a light breze blowing...
chopper impala you are half right it shrinks when you cool it with a wet rag ,spray bottel or even compressed air.
i have to agree with pimpin paint about his bed side manner, i own most of his pullmax tooling and its like pulling teeth to get an anwser when...
buy a cheap hole saw tubing notcher it will make it alot eaiser.
[anyone know of a supplier in nj for 18 and 19 ga.sheetmetal thanks
sure hits the nail right on the head !
Separate names with a comma.