The Jalopy Journal
First thing i would do is to put the wiring and solenoid back in the transmission that it came with . Then wire it with a brake pedal switch and a...
Thanks
What is the best aftermarket posi unit for a Ford 8-inch ?
They might be Goofy, but at least these people are taking an interest in our hobby !
Will the snow be gone by the 21st? :D
Didn't work in my 48 coupe . Had to make my own.
As much as I despise the Maine winter, we don't have to worry much about tornados, earth quakes, floods, hurricanes, wild fires, land slides, etc..
The older I get the more I hate winter . Aside from the cold and snow , its because I feel like its stealing valuable time while we wait for...
Please tell us more about the no wires manual lockup valve body.
I like to bring most wires to a terminal strip before going to a device. For example everything in the rear of my car ( lights fuel sending unit...
I started watching the video posted by a guy from Australia the other morning but had to get to work. I didn't save the link and for the life of...
Can the stainless steel band type clamps be used to butt-join a tail pipe to a muffler ? Butt-join meaning no slip joint of the smaller pipe...
:D
OMG .....it must be brutal down there is SC in the " dead of the winter". What ....40 degrees over night for a low....20 below here this morning.
Why would anyone not do everything possible to protect their kids??
Why is it that when I sell something it aint worth much but when I buy the same thing its priceless
Do you have drum-drum or disc-drum and is the napa unit compatible with what you have
3.55/4.11=0.86 so whatever your rpm is now with 4.11's just multiply that value by 0.86 and that will be the rpm with 3.55 gears.
Oldrelics you were right . The square shaft was twisted. I hated to do it but I had to cut off the handle then cut the square shaft again from...
Given a choice I'd go for the short door coupe.
Trying to remove the outside door handle of a 1947 Ford PU. Everything is loose, I've got the bottom of the door removed for patch panels and I...
Your story sure brings back memories. I just turned 65 myself. My first car was a nice 1940 Ford Coupe that I bought at age 16 for $100. It was a...
Sounds like Frank was one in a million. We need more like him in this world. God Bless him and all his family and friends.
Well it looks like good oil pressure , water temp and almost a full tank of gas comes with the cluster ! Looks like the charging system is ok too. :p
Heater ???????
[
I was just talking about this to my wife yesterday . When I was 9 I lost everything in a house fire . Did I say everything?? That's not right...
I took mine out Friday. Drove up to Waterville ( Maine ) and had the state inspection done. Nice day and a great ride . I was hoping to take a...
I run a MII in my 48 with 11 inch Granada rotors and GM calipers and power steering. I also have sway bars front and rear ( 8-inch granada rear )....
Even though I was able to take a nice 80 mile cruise in my 48 yesterday , it was certainly a rare thing here in Maine to do so on December 26th. I...
Separate names with a comma.