The Jalopy Journal
I have an after market one that was cast in aluminum. I have it hanging on the wall cause I never felt it had the right look. I would be...
Stainless is nice, durable etc.
Can you remove the oil pan? .
A good oxo/acel torch I found for sheet metal is the Cobra 2000. I bought their kit at the Hershey show a few years back. Took a little...
I recently bought a pair of side plate adapters from Bruce Schneider in Davisburg, MI. The adapters allow me to use my 35 or 41 bells on my...
I purchased a Chinese made GPS speedometer from E-Pay for around $50. Took a while to arrive but it installed easily and worked fine. It has the...
Last year I wanted a Winter's quick change rear axle but only had $2K. So I saved a year and now have $3K. But the Winters remains the carrot on...
Are you still taking orders for side plates? My center section is a Halibrand 12 bolt.
Hello, Does anyone have a repair/service manual for the Sun Electric CCT-10 coil condenser tester? I'm looking for the part numbers for the...
Regarding cabinet paint color, I used Ford DG,M6560A MDTEWHA Aquamarine Frost on my Sun 504. It was a reasonably good match. I used comet...
Great looking ride. Would look good in my garage.
Trying to find the courage to do the same to my Brookville. Nice planning, nice cuts. Looks professional to me.
Thanks Tic, best info I've come across on 32 Ford door locks.
Thanks everyone. Much work but found success. I purchase an undersized (1") dimple cutter from Eastwood and made the hole. A dimple cutter is...
345 Desoto above got it right.
Hello, Thank you for your reply. The last post on this subject is about 3 yrs old. Anyway, I had acquired a trans top shifter from a Jeep a year...
Making metal magic at it's finest. Very well done! Went to Brookville and took delivery of my 3-window body a couple years back. You have...
I was looking for a link or magazine article that shows how to make the hole in the top center of the 32 dash panel to accommodate the lighter's...
Hmmm! I have the T86 with the OD. Can you advise the the incompatibility problem with the top shifter and the OD unit? Can't seem to make the...
Hello, Much appreciate your reply. I knew that Jeep used this transmission with a top loader but didn't know the years. Regarding the 39 style...
Hello, Thanks for your reply. I also heard that an early Studebaker pick-up used a top loader also. But good luck finding one. HotRod-1
The Borg Warner 3 speed T-86 manual transmission for Ford has a sheet metal cover with 6 bolts on the top side near the front. This transmission...
I bought a fully boxed 32 frame with original rails from Bill in late 2010. The frame was exceptionally constructed in every manner. Frame was...
Yep, Hatch is right on, buy what we can hardly afford, then go from there. I can visualize a 32 Brookville in my garage at this very moment.
Hello, Was wondering if you had worked out this problem? I am rebuilding the rear axle assembly from a 41 Ford 1/2 ton pickup and am experiencing...
I think it's just a spacer. You could probably fabricate one from 1/16" brass using circle cutters and small files from Lowes or home depot.
Super Information. Thanks, HotRod-1
Separate names with a comma.