The Jalopy Journal
my 68 stevens silhouette 406 sbc
Peter Dean, when I was a kid he always found something for me to do to help him with his car and to a young teenager that really meant allot. and...
my Ol' lady is always asking me the same thing
I've used rustolium for touchups on heavy equipment after welding on them. the only problems I've found are color matching and turning flat if you...
concur, it's sad to see some potentially nice rides go to the "rat rod" side
I still have two or three, still use them when the need comes up
a few pics from a performance boats photo shoot of a friends really sweet nailhead powered 63 spitfire, a family boat since it was new
my mistake, I guess I should have taken a better look before opening my yapper, having never actually seeing the car and assuming that is what...
pop picking up my mother for a date in his impala
Pop's ol' "one owner all original cream puff" 72, almost ready for it's second motor
having a good ground strap from the block to the body and frame will reduce most electrolysis in the cooling system
smoked a couple of computers, bleed over on the stereo and TV, it all stoped when I found the bad ground wire in a conduit
sweet old wood flatty trbomax, it's about time to uncover that thing and get her wet again :D here's my old 68 Stevens w/406 sbc
marine tex epoxy will be your best bet, like olkarz say's some holes drilled in the steel will help
sweet old flatty, look's like you got the pickup to match it behind it
there should be a schematic on the inside of one of the panels, they're a little hard to read sometimes but it should show the pin position and...
make sure you use an epoxy primer or it will peel right off
spoolamatic?
hey Jay, welding the edge of the flange won't make your frame pull up or down, it will however shrink the inside edge of your rails and put a nice...
what's left of my memory
wow what a great story, I was a great fan of Bill Muncie when I was growing up. I used to love to watch him race at the thunderboat regatta in san...
was that the wreck that killed Bill Munce?
Holy Crap!
sweet looking float (for a squirter:D) J/K
my 68 stevens 406 SBC
I wouldn't say you're an idiot, if the paint is free, you got to use it :D
I don't think you'll have much luck, the neoprene impellers in the boat water pumps wouln't take the heat of a circulatory cooling system
good question, to get that many cubes don't you have to run a taller deck? I have a 406, and when I was building it I considered a 4" stroke and I...
SBC 400 in my sanger flatbottom Vdrive
Hey everybody, I'm just a socal welder who grew up going to El Marage and the salt flats. I'm trying to get going on building a drop tank car with...
Separate names with a comma.