The Jalopy Journal
thanks squirrel, i do appreciate the info.
i have a sbc with no casting numbers on the rear. it is a one piece rear main seal engine with a balanced 168 tooth flexplate. the starter bolt...
if you gave the parts number and manufacturer of the switch that would help.
41 willys........283 chevy
will the g body gm 10 bolt swap over into the s10 diff. i think they are both called 7.5, thanks.
you can use the bolt on yoke. find a flat type freeze plug to seal up the yoke where the bolt went thru, this way you no longer need the "o" ring...
i swapped a 1948 216 truck engine with a 1962 235 truck engine and everything bolted up, no problems.
Here's a '40 I just finished recently on an s10 truck chassis. It has a coil spring rear, 454 eng sit back 12 inches, 400 turbo, rides like a...
they ran me clean off of here just asking about modifying an s10 chassis. fact is, lots of these fellows are running s10 truck and blazer chassis...
i appreciate all the information........thanks
i'm selling a coupe on ebay and a fellow in ny has asked me to send him a copy of my title. any danger in doing this?
you're doing good work. i have a 40 ford i bought from that same fellow and i was impressed with the quality of the body.......keep up the good...
well, thanks to the hamb's help i figured it out. i had misplaced the bypass valve gismo and was trying to put a later one in. with the correct...
maybe thats the problem, i may be trying to put an adapter on there that it doesn't need to begin with. i'll take a fresh look at it tomorrow....
it has no adapter on it. it just looks different, than say my 348. the groove where the gasket goes actually has no groove, no inside wall to the...
i notice the oil filter adapters for the early small blocks all say won't fit the 67 nova 283 or 327.......how come? i have a 67 nova 283 and i...
has anyone tried the lotos or cut 50d plasma cutters?
the small 8 x 14 radiator will mount low in the grill and not block the main radiator. i will be able to tell just how much this helps, if any,...
i have a 40 ford on an s10 chassis with a 454 bbc. i'm running a 65 mustang radiator, thats all i could squeeze into it. it does suprisingly well,...
anyone ever need a little more cooling and install a small auxillary radiator, kinda like a heater core but a little larger? maybe a small engine...
don't walk away from a great deal like this................just run away......fast..........
a 1965 mustang v8 radiator will cool it and is close to that size and you can get them with sbc positioned inlet and outlet.......
i have a 40 tooth driven gear on the speedo cable. at 40 mph indicated i'm actually doing 50 mph. what gear do i need?........thanks
i have a 40 tooth driven gear on the end of the speedo cable. the speedo reads 30 when i'm doing 40 and when the speedo reads 40 i'm doing 50. how...
i ran into the same thing many moons back. what you need to do is find out the last known address of the last registered owner. send a letter...
i bought a repop vega box, came from china or taiwan, built very poorly and not a all internally like the real deal. you're better off with a used...
thanks big bad john......this rod building is a disease for some of us....i love it
well.....thanks
i'm new on here, but not new to rods. i'm currently building a fibreglass 40 ford coupe w/hood and full fenders, 454 powered, sitting 11 inches...
Separate names with a comma.