The Jalopy Journal
there is a wagon cap on ebay right now (as of last night) for I think under $50. I just did a ranchero so found out the hard way about this...
I baught a Chevette for my daughters back in the day, it had A/C and auto trans. With the air on, we had to pull over until it cooled the car,...
Just finished doing this on a Ranchero-pm me for a ton of info and resources, I referred to the Ford Falcon Forum, "TFFN" they will walk you thru...
I fixed up a bycicle tire on a tripod and attached playing cards to the rim. I fixed a pointer on the tripod so it pointed to a card when the rim...
This is a unibody, so make sure you look at the underside for rust issues, mainly where the rear springs attach at the front of the springs to the...
From Cottage Grove, near I-90/94 interchange
Just to muddy the waters.......it seems the coversation is mixing two separate elements here, the voltage needed to "trip" or engage the coil, and...
no tilt, it was lime green 2dr ht
I ran a '57 chev in Oahu some where outside Pearl City back in the late '60's early 70's while serving at Pearl Harbor............those were the...
Welcome from Cottage Grove.........
It isn't hard to do, but nxcess is correct, it will not roll down all the way as the inner fenderwell is in the way. If that is a problem, don't...
try this site kevinstang.com
get on the ford falcon forum, it has a wealth of info and resources.......re-doing a 63 for a friend...if you end up parting this out, I need a...
a good cleaning, and a clear coat.........I have also painted silver and clear coated, made cleaning it later alot easier. Dirt and stains seem to...
Try a series of spot welds with your mig.. after some practice you will be able to lay a series of spots in quick succession without blowing...
welcome from Cottage Grove
Fentons fit, no problem, to keep the pipe tucked up into the frame at the x-member, I cut a round hole on one side (don't remember which side the...
One application of a sealer, is adding a sealer agent to your last coat of high-build primer, this helps prevent the scracth or sand lines you may...
I put a Maverick 8" in mine in one weekend.........the hardest part was finding the 3.00 gear ratio, I run a C-4 with my "warmed over" flatty
ditto what 36bird said.....I run a regulalor with gage on my flatty with 2 stromburgs, run 1 1/2 to 2 lbs max with no problems. Never had problems...
radios were also mounted "under the dash"
check to see if your infra red heater has a closed combustion chamber that takes its combustion air from outside...........if so, no problem, it...
welcome from Cottage Grove, I,too, have a 50 shoe box, and am building a 63 falcon ranchero for a friend..good luck with your build and happy cruising
41 Ford I had once, functioned the same way, if memory serves me right.
Welcome from Cottage Grove... I was stationed at Pearl from '69-'70.spent many hrs on the drag strip outside Pearl City
Welcome from Cottage Grove, and say "hi" to Ted McDonald, the tractor puller guy if you know him...........
welcome from another shoebox lubber.........
welcome from Cottage Grove WI
I have mine mounted on the hinge side of the doors, on my '50 shoebox. I have mounted them at the same location on other cars with heavy doors as...
that would be just about every damn part I have ever purchased.........must be a desease.............
Separate names with a comma.