The Jalopy Journal
Very interesting thread. But something sticks in my mind, there was a comment earlier about using pure oxygen. Depending on the volume of the...
Cool. thank you very much, and sorry for posting on an old thread. I expecially liked the comment about over fill. makes sense.
Searched the forum for break in procedures. I have a 331 hemi that I put a new cam and lifters in, and I have seen several utube videos that show...
I have a 6v starter in a 331 poly ground it for long long periods of time, and no damage. Something wrong in the wiring, must have killed the...
well, I returned from europe, and took the motor apart. I was going to use it in a 26 3 window, but plans wound up in a 31 Tbucket. hemi exhausts...
Well, here is something that seriously works, but you have to be quick. Use a can of spray gasket remover. Spray a small area, and QUICKLY rub it...
Look what $350 can get you. :) 1926 dodge 2 dr.
I am not much on wishing. But there are a lot of shippers on http://uship.com . I have had super luck with them shipping projects, and some nice...
Heh: Nice shops. I work outside, sun and rain. Enuff room for 4 cars. Helps having a tire shop next door though, free air and electricity for a...
By the way, both exhaust manifolds, the trans, torque converter, intake manifold, and carb will all be replaced. So if someone wants any of these...
Well, I built a couple of these. One was in a 24 dodge rat rod with a mor drop axle. I mounted a mustang rack behind it, and just used it for the...
HI guys: Thanks for all the info. Regarding changing to a hemi, that is not in the plans. I like the look of the poly, and after all in 56 it...
Here is my poly motor. 56 chrysler windsor, planning on putting it in a 26 three window chrysler. tom
Hi guys, thanks for the input. The intake problem is solved, and most likely the transmission question as well. To clarify what motor I actually...
HI folks: Obviously I am new here, but not to rods. I have build a few TBuckets, etc, a lot of ford stuff because I have a bunch of parts. I have...
I got a bit better. The sets link is at http://www.flickr.com/photos/organize/?start_tab=one_set72157600498127142 This is pretty much a full...
Oops. I never tried to use the photo thing. Link 1 http://www.flickr.com/photos/57205282@N00/2311163603/ 2...
Well, bought a 27 "mostly" Dodge bros roadster, and welded it all up. Boat seats, 347 stroker, dual quads, c4, Caddy tilt steering, 20 pounds of...
All done and sold. :)
No drums on it. Thats the original prob.
Very good. Thank you all for the input. And for C9, extra thanks. I have found plenty of information, now just to digest it. :) Thanks a...
Hi: I purchased the "Swamp Witch", and now am planning on putting disc brakes on the early ford spindles. Does anyone know of a setup to do this...
Very nice to see the pictures of the car as it is built. I have bought the Swamp Witch from joe, and now there will be some more input on the...
Just a note to find a square cut on a tube. Use a plumbers tubing cutter. The rollers will keep it square, and make a perfect line to cut. All...
Separate names with a comma.