The Jalopy Journal
He was a great guy...
This place will tell you what's going on on any night. http://www.donspeeno.com/2011_Cruise_Nights.html
I've done it running a rectangular port Dart intake on my oval port heads. The engine would RPM about 600 higher over a Holley Strip Dominator intake.
Thanks!
My 52 Super 88 [IMG]
My 1952 Super 88 [IMG]
I've been running copper head gaskets in my Big Block Chevy street car since 2001 and all my race engines. All I have ever done anytime I have...
I grew up 3 blocks away from his shop,it was always a good day when the shop doors were open.
The jets do not come into play on a Holley at idle. I always restrict the idle circuit on a Holley with wire,they are built to be fat at a idle....
Stay away,junk.
To the top!!
Is the top of the block right above the bellhousing wet or dry? If it's wet intake or distributor. If it's dry and inside the bellhousing is...
I've run aluminum rods on the street in a big block Chevy engine but they were new. I would never run a used set. Sell them and the pistons you...
I like it,satin black has been done to death.
It will work both ways,I have tried it to find power. I made my own gaskets.
I've done it with no problems,picked more rpm's and moved the power curve in the motor,I had a set of ported oval ports. Just use the gaskets for...
If you want to head to the southside,163rd and Harlem in Tinley Park on Friday night and 134th and Bell Rd in Lemont on Saturday night. Both draw...
In expensive lifters are going to lead you to flat cam. Your better off buying a good lifter that will work with your cam.
I never use spacers,If you need more room just use 2 gaskets per side. I've never had a issue doing this.
That story comes up every few years,last I heard about 4 years ago was that Mike Alberts was trying to reopen it.
The jet is not used for idle. I restrict the idle circuit to clean up a fat idle.
Pump is bad.
If it can go from 250* to 190* in a minute and then you can drive it,I'd look at the gauge and sender.
Mark IV heads will work on VI block
Did you mix up the small wires to the solenoid or put it on the wrong side?
Looking good!!
Merchants crossing gets a lot of cars on Mondays. Fosters Grille on Wednesdays in Cape Coral gets a bunch of cars too. Email this guy,...
Your intake will work fine,never had a issue with one of those. The BG carbs have issues but if you got it cheap go thru it and try it.
I like the way it looks!!
The metering block gaskets will be different. Just match up the rest of the gaskets to see what will work and pick up the gaskets you will need,no...
Separate names with a comma.
The Jalopy Journal
