The Jalopy Journal
I'm not that good with Ford, does that have a points dist. and ballast resistor? If it does it could be your ballast resistor.
I had a 75 C-10 short box with a two piece drive line. Talking the guy I knew at the dealership, it was because the truck came with a turbo 400....
My guess is that it is 42/46 Chevy COE. That is my oh so educated guess. Shawn
Oh that is a continental I can't not count how many head gaskets that I have put on that kind of engine. There are in a lot of forklifts, and have...
Yes the ballast resistor is necessary or you will start to go through points. The wire from the s terminal of the starter will send 12v to the...
My 69 chevy pickup has factory power drums, with no prop valve. But if I put discs on then I would need to add a prop valve. Shawn
I agree you need to use lowered shocks for the lowered ride height that way the shock is not bottoming out, if this happens it will self clearance...
I agree with the above, unless you want them to be non removable. And studs usually never back out because they have contest press on them from...
I think that is all depends on the state, some stated are really slow about get title out. But I would give them a call and see what's up.
I think that you were very nice, I think that when you offer to repair his spindles at no cost. That was going above and beyond.
I just finished up my shop this spring. It is not very big it is just a 24 x 24, but it is what I could behind my house. I put in a 100 amp panel,...
I agree it would be hard to be competitive with a single car trailer, when it was a cross country haul. It would have to be done by someone that...
Fram filters have been blowing up for ever. The first job I had was at a parts store and if you cut apart a fram filter and a Wix you will see...
That's a nice go kart, I can't wait till my son is old enough to build some thing like that. I think that is great you are spend time with your...
It all depends if the primer that you are using has any sealing qualities. A lot of the spray bomb have zero sealing qualities. You have to make...
Those old truck trannys are bullet proof, as long as yours is in good shape it will shift fine. Once you get good at shifting you only need the...
I agree nice truck, there looks to be more to the aluminum along the top of the bed. I also like the plates, please tell me your wife is a teacher.
I have had it happen on the other end on a O/T car, the guy was to quick to say, look I have a clean title. To the point that I was unsure if it...
Spokane has a modified exhaust law, but it seems to be only be enforced when it applies to punk kids. One of the kids that use to work for me, a...
It is hard not to like a truck that is done as well as that one is.
Yes is it called Wetter Water, Yes it can be used with water only with corrosive protection included or be used with antifreeze. I have never used...
I priced out the green pvc pipe that is rated for compressed air and it was more expensive that copper pipe. So it was a no brainier when I went...
I just did my in copper, it was cheaper than Garage Pak and it was easier than black pipe. That is for people that do not have access to a pipe...
If you want the cool factor of running six carbs, you should have to pay the price and run them all. And it is going to be really hard to get all...
I have also seen where you need to support one end of the starter so it will not rock during cranking. But you usually shim a start when the...
I would go 2 1/2 the bigger pipe just sounds better.
That sounds like a coil to me, but that is just my 2 cents.
I think you should keep the conv. more stock and go wild on the hardtop. But that is just my 2 cents. They are your cars have fun and build them...
If it is just one of the rocker arm is you need to figure out why, it is one of three things that I can think of. One bent push rod, bad push rod,...
One other thing that works good if the broken bolt is pointed in a vertical position you can make a little ring of grease around the outside of...
Separate names with a comma.