The Jalopy Journal
I’d like to raise the rear of my 51 Chevy about 1"-2". I’ve already re-arched the springs. Also, I know you can flip the shackles from the stock...
I already have a steel table I built about 15 years ago, the top is about 6'x3', my 50# anvil sits on it, its strong and its at a good height for...
SOLD!!!
Sold!!!
SOLD!
Pictures below are part of a complete set of bbc solid roller lifters I got in a parts trade about 12 years ago. I'm thinking of cleaning them up...
First time setting up a rear. Got this pattern after using a .012" pinion assembly to housing shim and setting the backlash with the dial...
These are not made in china reproduction, but genuine GM made in the USA quality parts from a Texas car. 49-54 Chevy Passenger Car 53-62 Corvette...
SOLD! :)
SOLD!!
SOLD
.
,
I was getting ready to narrow 2 Ford 9" housings, 1 for a current project and 1 for a future build. The housing for the current project only...
I've got a nice condition 2.91 ratio 9" ring and pinion set in a chunk out of a 1958 Ford. I'd like to use just the ring and pinion in another...
This wheel came on my 51 Chevy. It looks like a 1949-52ish wheel, except there are no clips to retain the hub cap. It has the holes for the...
I want to build a tilt front end, but it needs to move forward before it tilts. Two options are to make it slide forward and tilt or build a dual...
Anyone remember The ET Shops in Chicago & Addison Illinois? About 40+ years ago I lived in the Chicago area & worked at a gas station on Lake...
These were pulled off my 1951 Chevy Bel Air. Updates your old Huck to better working Bendix brakes. Includes Bolts, Spacers, Backing Plates,...
1955-57 Chevy GM 3 Speed Overdrive Transmission. Comes with Bellhousing and a Sparkomatic Shifter in good condition. Cool set up for your back to...
I recently pulled out the center section on the 9" rear end in my car. Gravity was there to help me get it out, but I knew putting it back in...
Craziest thing, while driving down the highway at about 70 mph I had BOTH axles come out of the 1957 Ford 9” housing in my 32 sedan. It happened...
I've got a 51 Chevy I beam axle I'm trying to set up with cross steering. I'm using the stock lower arms with the tie rod at the rear. I cut the...
Does anyone know what specific year and model cars or trucks came from the factory with a 525 reverse rotation steering box? I know a lot of GM...
Question: Does one clutch "Z" bar arm need to be longer than the other for mechanical advantage or can they be the same length, using the clutch...
I'm starting this build thread on a car I've had siting for a long time and just started building. I've received a lot of help from this board,...
I'm mocking up a 51 Chevy car with an early 50s Chevy 1/2 ton I beam axle. The tie rod is behind the axle and a cross steer steering box is in...
Separate names with a comma.