The Jalopy Journal
On two o/t projects i used butyl based sound deadener, and mass loaded vinyl. I was happy with the results. Used it to replace water sheilds,...
I have a 49 with 383/torqueflight. Was a project my dad amd i started on when i was 16, but never finished. Looking at it now, i want to change...
Top center in the photo Jnkyarddog_1 posted, should be the same as 69 mustang 5.8 a/c idler. Rock auto has them for around $15.
Just like 19Fordy said, get up some before & after pics showing a few levels of prep.
I'm in. 49 more door.
Yep, definitely the 5 spoke 1st design. I like it alot!
I actually think this is pretty good (wheel #1), like to see it in a 5 spoke though. It should look just as good on a drum as a disk setup....
My '49 Plymouth has left hand lug Bolts on the pass side... Nuts and studs are a bit easier to line up the rim with.
Bump for the weekend... :D
Watching in SE Michigan.
Thanks Rusty!
Thanks guys, the box was my dad's and also had a gas cap and owners manual for a 50 ford.
Just finished reading through this thread, and I have to say that it looks like you picked up a great first project! The burn mark on the...
So digging around in some boxes, I came across this locking gas cap. The V8 emblem swivels to the side. I like it, and will probably keep it on...
You'll probably be interested in this thread... http://www.jalopyjournal.com/forum/showthread.php?t=397594&highlight=extinct
Looks pretty simple, got any friends with a lathe in the garage? The only problem I can think of would be if the bolt is hardened. In that case...
Nice score on the vice, looks like it will last longer than you will. Oh yeah, 6 1/2" Wilton bullet, and misc. garbage vices floating...
Subscribed, lot of good info for me to use on my 49. :) On a side note, in the last set of pics, it looks like you have the calipers on the...
I may have just found my new parts place. :)
Sounds exactly perfect for this forum. :)
Finally made it through the thread. Great history, family, and workmanship. Keep us updated!
I agree with rustyangels, JohnEvans, and Kennkat, Fluid not returning to the Master Cylinder. Follow their suggestions.
If it were me, I'd do like the others said, but throw some grease or oil on the rod bearings and caps and put them back on until you can get the...
I had the issue you are talking about in my O/T 68 Mustang with a 302 and shift kit. Only happened when I got on it hard. With new stock type...
:confused: I don't post much, but apparently you haven't been paying much attention to the news over the last few years as it applies to unions...
One more here....
I think This is what you're talking about: http://www.motoradusa.com/products/failsafethermo/index.html
One more thanks for the pile...
What kind of carbs, and what fuel pressure are you running?
I think this is what you're talking about, Ford Cobra Jet logo from the 60's.
Separate names with a comma.