The Jalopy Journal
castings should start 13 11 or 10 but v codes are for year/model v720080 is 1955
merry christmas rocky good to see raisin city again
there is vac at idle but the ? would be at what point over drive does it build pressure? boost builds under load so when does the point of...
x2 bet those upper rod bearings are copper for sure
you need to check the rod to piston clearance when its in the bore and mounted on the crank should be .050-.300 on the crank end the side...
a 16th is .125 or 125thousands clearance
good stuff
@petrolhead seriously read and try this http://www.jalopyjournal.com/forum/showthread.php?t=488291&highlight=road+trip enjoy
x2 :p
i dont think those exist but could be wrong might have to cobble something out of a 4x4 or van(a100) combo?
i believe the ground is internal or on ring basically and just 1 wire goes to the sender from gauge
i believe it takes a 0-90 ohm sender like 99 % sure hth
and get a kit with a new "turkey tray" or put a new one in if you pull it and do gasket/rattle can job good luck
im still confused why not 9"??
uuhhh im confused why not 9" ???
double check the #s and get a head #
its a shame what happened to romos
pics http://www.jalopyjournal.com/forum/showthread.php?t=477649
sweet now its like 3 threads need to group them
sucker you just fooled yourself u cool man ?? u cool ?
probly he was next to us lol
try this http://www.usbodysource.com/ go down and click on the 64-69dart then installed photos link on the one piece front end whole world of fun
o cool i knew it was something to pay attention to
no the 351 has a diff pan size
try this http://www.jalopyjournal.com/forum/showthread.php?t=413954&page=7
try this http://www.bowdenengineparts.co.nz/pdf/pistons.pdf
is this for burnouts?
probly 180 out was the marks on the bal close to the marks on the cover when you put the dis in?
any casting #s?
dist has nothing to do with comp it just fires it with spark
Separate names with a comma.