The Jalopy Journal
I have no place to store this coupe and its parts. It is up for sale, $2000. The body is very solid. It has a Mustang II front suspension with...
I have a T bucket that the tie rod is in the front and I doubt the akerman is correct. I did not build it and it is a shorter wheel base than the...
I am trying to use a 37 to 41 front axle under a square tube frame for a 30 tudor. I would like to put the tie rod out front to allow more room...
deleted, repetition.
Find you a T bucket frame and give it a home.
You may need to go past your marks. Think of it like tightening your front wheel bearings. With the ring gear in the way it is hard to feel the...
See, it does not say anything about carrying extra battery acid in the washer bottle.
You beat me to it. That is just on the west side of Birmingham off I-59
The master cyl push rod does not seem to be in line with the master cyl, so I am concluding you have a bell crank or another pivot arm making the...
this is what you want to work from. If you can find your cam card or get the info, it will tell you what rpm your tq peak is. I would try to run...
I guess if you disconnected the pump, you could fill it with something nice, like battery acid. There may even be some stains that are clear...
Sounds like the pivot points on the linkage are too tight.The long rod or rods running from the lower column to the trans arms should pivot at the...
I just scanned the thread and saw the magnet suggestion. If it was not mentioned the type of magnets used in computer hard drives, the name...
You may not want this on your engine, but a lot of supercharged engines run an in line catch can, which you have room for behind the passenger...
Should have a screw in plug in the lower center of each metering block.
Columbo said the tripowerbird indicates Ford.
You can buy the bowl and block gaskets separate. You may have to also buy a secondary power valve. If you need a whole kit, buy it and then buy...
I have a block in the shop for boring right now. I have already modified the block for the filter. I plan on running an electric fuel pump, thus...
Might work good on cast iron also.
Funny, but how many dummies really get stuck changing their oil at 3000 mile intervals. I have 2 vehicles with 300,000 miles and I change them at...
Very nice car. If anyone needs its mate check out the Sprint listed in classifieds.
My 99 Cobra has it and have seen it advertised in after market systems.
How are we doing on this problem? The front bowl may also be overflowing, but the butterflies would be more open to let drain into the intake.
I appreciate a good FE engine and enthusiast. I have a little trouble with your total ign adv. If you have not, I would come down at least a...
With manual steering, a quicker ratio is usually at trade off for higher turning resistance. If you scratch your ass and end up doing a bat turn,...
Fuel level is supposed to be BELOW the site hole. You should have to rock the car to get any to slosh out. I cannot remember if we discussed...
You'll have to get in line for a Mallory unit, good luck.
Go to the distributor and make sure you are getting full advance around 26 to 2800 rpm. Run prem gas and run as much advance as you can without...
I got a TCI Ford AOD that has lasted about 8 years sitting on the floor of my garage. Shifted at 3800 rpm wot. I could get no sensible or...
A length of rubber hose that will reach your ear as you move it around the manifolds will quickly tell you the exact location.
Separate names with a comma.