The Jalopy Journal
I noticed when I disassemble the PG that the clutch drum thrust washer was missing. I ordered one, but now it seems as if it was not...
thanks a ton
Is there a special tool to remove the speedo gear off the output shaft?
A special trick?
Jorge [ATTACH] [ATTACH]
Given the angle of the tube, is there an alternate part that i could use?
Does anyone have a line on of these oil pump screens?
Searched all over but the ones found don't look anything like the one that...
thanks a ton. all good info as always fellas.
Hello you all knuckle busters enthusiast, quick question,
Just picked up a 1992 S10 rear end for the 48 Fleetmaster, and I was wondering if it...
10-4 thanks folks
From what year to what year is the preferred 4x4 S-10 rear end, for a 48 Fleetmaster.?
thank you all
Well that's why I come here for knowledge, there it was 9254, right where you said.
Heading over to check that out, on the readings theyade it sound like the kits were very specific to each number.... but learn something new every...
It's a Rochester carb, it was in a 56 Chevy 235.
Any guesses as to the stamped number? Trying to get the rebuild kit for it....
So it's like a spacer..... engine-spacer-bellhousing-trans.
Just picked up a 56 PG and the seller also gave me this part, he called it an adapter....
Does this piece replaces the 235 bellhousing?...
New cam and lifters on the way lol
This crash course on chevy inline 6 ots something else, I sure picked a "good" one
I may have found the culprit....mayyyyybe. after looking over the cam, well that one seems to be a goner. [ATTACH]
OK so the deep clean.... basically a good clean, try to get all the grime out and what not.
As to what was wrong with the one bad one, it has a...
Is it okay to replace a single lifter, or should I replace them all?
My gut is telling me to replace them all, but I'm looking for some...
Yes the motor is all apart. I noticed the chipped areas on the gear and of course decided to change it. It's just that after all the reading I've...
Sorry didn't think of it lol it's out of a 1955 Chevy
As I attempted to remove the gear on the press, this thing just fell apart. What was the gear made out off back 55?
Yeap not going that route. Let me ask you, is there a year where the PG was matched with a torque tube?
Good morning fellas,
After an okay night of sleep, I have a few more questions (which I'll make sure to write correctly , learned my lesson...
no sweat. I am currently tearing the 235 apart to send out to the machine shop. I want the motor and trans pretty much done before i even tear...
good point there,
ha ha ha I am, different animal for sure. from light and fast to heavy and much slower, but im digging it
Separate names with a comma.