The Jalopy Journal
Oil drain plugs from a 2002 Dodge 360 have a nice, built in rubber seal. Make sure the female threads are the same (1/2"x20) when retrofitting.
As much as I love a SBC, I went with the Chrysler 392 because it can motovate a FED to 4 second runs down the 1320.
A short piece of rubber hose can serve as a depth gauge/bumper when slid over a drill bit.
64 IH 3/4 ton awd pto 345 4 speed
When installing new races into a rear axle housing, I put the races in the freezer first. when they are truly cold, grease and tap them in place...
When the shop sink, tub or shower drains slow, a shop vac will usually suck it clean in about 10 seconds. Have needle nose pliers handy. Take the...
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
found on boogle images[ATTACH]
RTFM (read the friggin manual)
Removing a pitman arm. Install your cheapy pitman arm puller, snug it down with a wrench, add a little heat from a propane torch on the pitman arm...
still sitting in my front yard.......[ATTACH]
I shot this in Bodie, CA. Circa 2001[ATTACH]
Bodie [ATTACH] .
Had to look it up. http://dictionary.reference.com/browse/inflammable?s=t
Yes, my 350/700R4 had that same clunk. I always figured it was U-joints or
excess ring and pinion backlash. I did fluid, filter and refilled it...
I would also like to say thanks.
Black and white nails it.
This thread just reminded me, my 3/8" ratchet is still between inner and outer Left fender.
Flame spread putty. Use it generously around the penetrations for wires and cables into the cab....
If it's cut out for a spreadbore it will adapt to a squarebore manifold.
She is beauty.
Hearts and prayers go out to his family.
The world lost another pioneer.
I remember as a kid, driving across country with my family in the 60s,...
42 IH k3
Long live Clint Eastwood.
Haven't seen all 34 pages, here is a gull wing.
Separate names with a comma.