The Jalopy Journal
On a '51 8BA Ford engine I bought I am having trouble finding a serial# on it. All I can find is two letter "A"s stamped where the number should...
I know this has been discussed before but I can't find the thread. Can I use velcro to attach the upholstery panels on my '27 rod doors etc. Phil
From those of you who have already done this; On my '27 Ford Tudor, should I install metal lifter strip on the bottom of the glass before or...
Just wonderin' since I've been in Florida for a number of years how many Bull Run Street Rodders frequent this site. This was my ride when I was...
How important is it that 94 carbs sit parallel with the ground? Phil
My poor comprehension of the English language (hillbilly here) got me into trouble again on my last post. My question should have said, "How...
How far back do electric radiator fans go? Phil
Going thru my old slips to find the best.
Running an 8BA with dual Holly 94's, straight linkage. What power valves should I be using. Phil
My 8BA idles just fine but it tends to stall when I come to a stop. I usually need the choke to get it started again. Fixed one before with this...
Will a M15 oil pump fit in an 8BA with a truck oil pan (the one with the cleanout)? Phil
Will the radiator hose shown in the below picture rising above the level of the radiator tank cause a problem? [ATTACH]
Engine has been sitting for 2-3 years. Started it today for a short test. Got no oil pressure. Afraid to run it very long. Could the oil have...
I'd like to see some suicide front end constructs to compare mine with. [ATTACH]
I know a banjo rear properly filled with lube would be 1/2 below the filler hole but accurately how much does it measure in ounces? -Phil
I have an Omega Kustom Instruments Electronic Speedometer. What GPS sensor have u successfully used with it?
Are any of you guys using a GPS speed sensor with your speedometer. If they are reliable it would sure make things easier for me and my 39...
To get my current project on the road by the end of this summer.[ATTACH]
I am using an F1 steering box in my '27 T Tudor Project. However I need to rebuild it(rust in the bearings). I am not familiar with these boxes. I...
I'm 78 and still building. How about some others out there. [ATTACH] Also another building hobby. [ATTACH]
The space left over for seats after the installation of the driveshaft tunnel is pretty narrow. GLIDE seats are too wide. A bench would be too...
8BA with standard 3 speed....Will an 11 inch clutch clear a standard 3 speed bellhousing? I hooked up my battery today and tried the starter. I...
On my last project in the '90's, a '34 Pickup, I used Painless Wiring. It workout ok. There is also EZ, AmericanAutoWire, and a host of others...
It was ok to restore a '34 tag when I lived in Virginia. I have a 1927 Florida Tag for my '27 Tudor. Is it ok (legal) to restore a tag in...
[ATTACH] I am building a late 40's/early 50's '27 T Tudor. I am trying to keep it pretty period correct. I have a 1927 Florida tag for it but...
Good or bad?
I know it sounds simple, but if one overthinks it enough, it can be confusing to a simple mind like mine. I have not found a technical definition...
What would be a good choice for a manual cylinder for 40/50's drum/drum brakes? Phil
[ATTACH] Crazy days......
Just purchased a 78-7006 3-speed pickup transmission. I am having a hard time trying to find a slip yoke. Anyone know where to look for a purchase?
Separate names with a comma.
The Jalopy Journal
