The Jalopy Journal
The brass condenser on my Mallory YC finally gave out. I'm looking for a replacement, but they are tough to find in usable condition. Is there a...
After running my Mallory YC with points and condenser for 3 years, I've decided to do a pertronix conversion. Trying to find another usable...
Here's my setup. Any advise would be appreciated in sorting this out. I just got this thing on the road after a 2 year build. Driven about 30...
I've done some searches and haven't turned up much on these. I'm going to attempt to wire my project from scratch with cloth covered wire. I...
So my T-5 to 283 swap is becoming a pain. Started with a Hamilton Intakes adapter spacer and everything fits together nicely with the exception...
I'm running an early 621 bell on my 283 with a Wilwood slave. 11 in clutch, short throw out bearing etc. I picked up my current clutch fork with...
Whats the correct length yoke for an S-10 T5 trans? Did a search but cannot find anything on yoke lengths.
Hello, I'm looking to save some trial and error searching for radiator hoses for my 283. Top looks pretty straight forward, bottom I'm not sure....
Can someone school me on what yokes will fit an 80's S10 T-5 trans? Thanks in advance.
Title should say " wound " not would, hey it's early in the a.m. Anyone know of a source for cloth covered modern spiral wound plug wires? Taylor...
Any Alliance vendors that sell Chassis Engineering products? Other than Riley Auto.
I'm about to bite the bullet and order up a new radiator for my 34 p.u. project. Here's the low-down.... Mild 1958 283, 10-1 compression, L79...
Anyone using one of these adapters with an S10 T5 behind a SBC ? I'm weighing all of the install options, spacer adapter vs cutting or changing...
I know, I know, I'm going to be planting a little 283 Chev in my 34 pickup. I'll be using an early Hurst mount located in the stock flathead...
Hello, looking for feedback on Pete & Jakes under floor hydraulic clutch and brake kit, non-boosted. I'm considering installing one in a stock 34...
A buddy emailed me this crappy pic of a front end for sale. Seller said it's off a 36 ford, doesn't look right to me. I'm looking for a juice...
Take a look at this....Nuff said. http://spokane.craigslist.org/cto/834059442.html
Hello, I finished up the 5" chop on my cab a couple of weeks ago. I'm going to pull the wood support out of the beltline area and fill the holes....
Hey I'm headed to San Antonio next Friday for a week to visit friends. Looking for a couple of rod shops to visit and pick up some swag etc. Any...
Just got my new wheels and tires from Coker today. I am very happy with them and the service. Hector hooked me up with the perfect combo for my...
I'm getting ready to phone Coker for a new set of wheels and tires. Who's our hook-up for the hamb discount, and who's a great sales rep with...
Hello all. I'm getting ready to lower the lid on my 34 pickup. Before I dig in I'd like some opinions on how much to remove. I'm shooting for a...
Hello, I visit the garage journal site a bunch but really think I'll get better opinions and advice over here. I just built a new shop at home...
Please help me ID this dash. I've been told and it looks to be a 32 three window, but the guage panel throws me off. The aluminum added to the...
Hello, was just signing up for the Alliance and was looking to order up a set of wheels and tires. Question, how long does it take for my...
Hello, one last shot at looking for a decent set of used wheels & tires for my 34 highboy pickup. Can't seem to come up with anything, so where's...
Separate names with a comma.
The Jalopy Journal