The Jalopy Journal
Nope still server not found Firefox win 7
There is an easier way to find out what you have. 59a wheel has blind pressure plate bolt holes.
8ba wheel pressure plate bolt holes go completely...
Yup x2 ^^^
The oil should be 10w30. Non detergent oil what planet is your friend from???
This is 2015 not 1915. No need for any other oil if the engine was...
Covers don't change it is the pan.
I have done 1000's of liners and they work quite well.
To answer the question about the kit you need to purchase with the appropriate carbide...
A also common place for cracks is from the valve seat down into the port and you don't have the valves out in your pic so take a look there also.
You don't require any main brg support with your engine .You won't make 200 hp with that fire breathing dragon.Just use the stock main caps.To...
You may have troubles with the today's gas and a replacement line compatibility.
Bearings are produced with the od oversize to accommodate the larger honed hole in the big end. Done quite often.
Done all the time take it to a good machine shop and have them stitch it up that is not rocket science.
Drilling is one thing to deal with now tapping a hole will not be an easy task. A normal tap isn't go to cut it.Source a replacement and be done...
What type of tig machine do you plan on using?
Yes you can do steel sheet metal without a foot pedal but unless you are a accomplished tig weldor
there will be somewhat of a steep learning...
A tig with pulse and a low amp settings starting at about 2 amps and going upwards from there should get it done for you no problems.Backing with...
Try a compression test or a leak-down to determine problem.
Dynasty 200 dx uses any power you have. Water cooled weld craft crafter torch.
Home grown cooler.Has good warranty program and parts are...
Acceptable but blue smoke is usually worn valve guides.
Google soda blasting carbs.
You won't see any difference with a 1.6 on the street.Do up a good ignition system.
Need to do lots of seat work for 1.6 OK if you can do it...
Only thing after points is coil.
Google is your friend for removing broken bolts from Flathead v8
Standard pump is all you need.
Nope The rear cam bearing on a ford flatty is not pressure fed.
You need to research that before you make that quote about bearing oil pressure...
You could do that if the fit was correct its not rocket science.It only has to go past the center as that is where the orifice is.:D
Don't use 8ba rods on a 59a crank.
Leaving out the pump rod won't result in no oil pressure on an 8ba.
Leaving out the bushing will.
Separate names with a comma.