The Jalopy Journal
was driving from melbourne to wangaratta up the hume made it to benalla, stripped fibre gear, never again :mad:
I have used hardened steel straight cut timing gears from a clark forklift on a grey motor i built when i was an apprentice,as the forklift ran...
I have seen one set up with a "J" model Bedford two speed diff actuator that was 12v,
guy said it worked really good.
adjustable push rods, ????
master cyl rubbers probably swollen up, making it stick in different positions
You need to buy some more smoke to replace the smoke that escaped.
Shitty Fuel ??
I wonder if any of the Chinesium front end parts are cast, could spell disaster.:eek::eek::eek:
Being the owner of a 1921 Harley Davidson F model in original running condition i have always looked at Dale's collection in awe. He has collected...
Only the tourists drink fosters, there are much better beers in OZ
P.S Don't forget dizzy's and diffs.
The only problem with buying a 327/350 from Australia is all of the ones for sale SEEM to have come out of a monaro.
Just like all 327 come from...
Don't forget to put some anti-seize on the axle flange when you put it back together. ;)
I use a forklift propane safety switch, primes for 3 seconds then shuts of until it gets a signal from tach wire or coil neg. ;)
Yep, thru the floor and into the frame rail
No need to remove carby, just undo the four retaining screws and it should come off. you might need a new bowl gasket if you damage the old one. :)
have you checked what your total timing is at 3000 rpm ??
I had at one stage 9 cars and 3 motor bikes, have been thinning out the herd as i am going to retire.
Will keep my 32 ford, 57 olds and 21 harley...
Go onto the Pertronix website, they show you how to test components.
I put a 340 oil pump conversion from hot heads in my 331, with 20/50 oil it runs at 85-90 psi cold,
once it heats up it drops down to 55 at 3000 rpm.
I purchased a 1963 plymouth valiant signet 200 coupe in 2015 and imported it into Australia,
I am slowly fixing it up to give to my middle...
I have Halon extinguishers in all of my cars. Hope i never have to use them.
put a VW kombi out once at my front gate carried one ever since
I was workshop manager at an earth moving company in Ballarat Victoria, and they had a lot of Dresser equipment
ex army TD15 dozers TD 20 dozers...
When i worked at Komatsu heavy equipment there was a sweedish guy there that we called 6.9, he always asked us why we called him that. His real...
Have you tried changing the plugs, my 68 corvair did the exact same thing. Checked everything, finally fitted a new set of spark plugs and it...
Something like this.
you should try dealing with the early Porsche crowd when it comes to numbers matching and factory correct.o_O:confused:
cheap is not good
good is not cheap
Separate names with a comma.