The Jalopy Journal
I can't tell. the damper is out and in the USA (Dale Manufacturing), but they can't rebuild the riveted hub style dampers. But the timing tab is...
Mine old damper is only 6 inches
Thanks Squirrel. You mention the 350. So when I replace the engine to a 350 I have to get a different damper? There is not much room between the...
Wouldn't mind to get a later styl. Just not sure what damper will fit
Ok. What is the different Mike? Always good to learn something
I own a 1959 Chevrolet Bel Air with a 283. engine. I have to replace or repair the 62 year old harmonic balancer.
It is the...
Good idea. Thanks
Thank you. I have a safety switch in the trunk. I installed a Ford styl safety switch
I have a question. I think I know the answer but like to double check.
On one of my cars I installed many years ago a Edelbrock 1792 Fuel pump...
Thanks for your help
I have a question about a 1995 Chevrolet 3500 Van engine. The Van engine is a 4 bolt engine and cars engines are 2 bolt engines I know that. I...
Ok, I give it a try without the 10 ohm resistor. Will see what happens.
Ok , Thank you
Yes it has, I have the same wire diagram. I just was wondering how the set up with the 10 ohm resistor is
Thanks Jim. I was looking at something like this too, just was wondering about the small wire.
I know some in the H A M B group did an generator to alternator conversion. My alternator and most of the wire are installed. My question is what...
I looks like 1/2"NF , but every Nut I bought does not fit
[ATTACH] What seize is the Power Steering Pump Pulley Nut? I lost mine and I can't find any information on the internet. Our local part stores in...
You are correct, there is a little noise. I bought a Edelbrock pump almost no noise. All my old cars have a electric pump. Fist help to start the...
I have to check it. Thanks
How does it work. I never saw a inertia type before
I have a 1959 Buick with an 364 engine. I bought a eclectic fuel pump and I am in process to install the pump. I know I should install a oil...
Thanks for the advice, everyone.
Ok, I have a question. AGAIN.
I replaced the engine in my 59 Bel Air with a 350 engine and a HEI distributor. What would be the best way to...
Does anybody has the Small Block Chevy torque Engine Specifications for the
motor mounts to engine
motor mounts to frame
motor mounts to motor...
Separate names with a comma.