The Jalopy Journal
Yes , a stock Ford spring has the eye rolled the other way .
The photo is not a Ford spring , but it shows what I'm saying .
Or you could use a stock eye spring .
If you want to go higher use a stock ( non drop ) axle .
I believe the Merc wheel centers have a " bump " on the hub cap nub that keeps the cap firmly on .
With the Lincoln rim , the wheel center looks...
I have a set of '39 pedals for sale in the classifieds
1939 Ford pedal assembly ,
$175.00 plus shipping
Is it a fender problem or a chassis problem ?
Was your wheel centered with the original fenders ?
someone should but my '32 tudor , I'll never finish it . . .
Does your car have coilovers ?
If so , disconnect or remove them .
Things will be a lot easier .
maybe they require adjustable push rods . . .
Tell me . . . now , what has Bill done to " ONO ' ?! has he screwed it up even more than when I last saw it many years ago when he had changed it...
New Blower manifold for 331 / 354 / 392 Chrysler Hemi
For 671 Blower .
Shipping is on you .
Yes , you are right , vibration was / is a problem with this set up .
When Rick had the engine rebuilt , is was run on a dyno .
I hope I can clear up the Winfield " 2 up / 2 down " deal , as there is incorrect info on here .
On a stock T engine the firing order is 1 2 4 3 ....
My take . . .
For me , this is a sad ending to this car's story .
When Jake let it go to his buddy , Ron Jones , he helped Ron with a lot of the...
What they said . . . '33 - '36 .
Anything higher than this is not going to clear the stock floor .
Things are really tight right there .
On an original '32 Ford , the access hole in the floor is over the bulkhead fittings at the forward edge of the gas tank .
There is no access over...
Though , Clyde Adams & Myron Stevens & others , built those type of frames , Harry Miller supplied the blue prints . I have copies of the frame...
What he said !
Bore out a stock brass T gas cap , & silver solder a neck into it .
Model T rear spring hangers are 48 inches , center to center .
Hope this helps
Model A front perches are 11/16 ID .
If you had just called Pete & Jakes , you would have found that
they have the bushings you are looking for !
I'd really double check the throttle linkage .
Watch what happens when you drop it in gear .
I've seen it be a problem , especially with cable...
you could have your old ones " Oversized " by " hard chroming "
Hard to believe this car has ever been changed since the original build .
Even the pinstriping on the front crossmember is original !
That chip is at the end of the scroll , most of your driving & turning is done in the middle part of the scroll . Hardly any steering happens at...
I'll never forget the first time I saw this car .
I was at a swap meet with my dad & Joe came driving in .
It looked so cool & had a great sound !
Take a look at the control arms under 1960's Chevy pickups .
This might be a good way to get to where you are going .
Separate names with a comma.