The Jalopy Journal
There is a formula for filter area needed.
ci x rpm divided by 20,839 equals filter area needed.
This link is for model A but principle is same....
Here is my 276 with K&N filters sized to flow.
I used a Tardel K member, but that was years ago when they were more plentiful. The F1 crossmember and pedals works well. There are many build...
I contacted Posies about removing leaves from their rear Model A spring. They told me to start at the top leaf and remove the leaves in order. If...
I used Rattletrap by Fatmat in my roadster. No problems. If I remember they had free shipping.
Cheaper than Dynamat.
There are some V8-60 guys on early V8 forum Ford Barn.
Rod tops makes a kit for 28-29.
I had a local lumber yard order Baltic Birch for my roadster. It is nice to work with.
I used short P&J shocks. I shortened an F1 bracket and welded on a the end of a Model A light bar.
No vibration driving.[ATTACH]
Normally on the early 32 or Model A you do not set pinion depth. As xix said, if there is too much backlash you can shim pinion.
You can check...
A balanced crank also saves wear on the center main. All in all worth it if rebuilding engine.
[ATTACH] Pete & Jakes shorty
I bought a fitted grill and shell from Brookville. That was several years ago. I do not know how quality is now. Mine was fine.
Does not look safe to me. Not much holding that spring on going over a bump at 70.
U S radiator makes good ones. You can get different heights and the lower tanks are compact. They moved the outlets in 1/2 inch to match water...
It takes around 14 volts to charge AGM or regular batteries. You might need to check your generator or alternator.
I have an Odyssey AGM battery...
"I don't own a radiator. So if one can work with a totally flat crossmember, it certainly will work with mine."
What I was saying is there may...
Have you tried your radiator. Mine takes up space below the mounting pads and is close to the u bolts with a stock crossmember.
I have a Whitney Generator conversion on my roadster. They use Ford generator end plates with an aluminum body. The ford bearings will take the...
[ATTACH] Classic,s. You can compare indicated speed with a phone GPS and use a chart to calibrate the
Speedometer for any tire or gear ratio....
Dave Havlir at House Of Fab posts on HAMB and makes them.
I have had 2 new Mallory distributors. I did not like the advance curve on either one . I decided to keep stock distributor rather than recurving...
I installed everything with clamps on the mounts and made sure every thing fit before I welded anything.
Here is some info. Many ways to do the rears. Pistn-Brokes is a good one....
pm charlie ny on Ford Barn V8. He has parts.
I had the grill and shell with same problems. I sold them and ordered an assembled grill from Brookville. One less thing to struggle with.
[ATTACH] I use an Oddysey pc 680 under the seat. This battery was tested for 3 years by CT1932Ford
and reviewed on here. I have used it for 3...
Power gen is only listed for non fan use.
Powermaster 82011 PowerGEN 1939-48 Ford Flathead Alternator, 12-Volt
E J Whitney can convert your generator to an alternator. It is rated at 40 amps. I use one in my roadster and I have halogen lights with no...
[ATTACH] I have the hot rod works conversion to 9” axles but with early Ford brakes. You can get 9” ends from them also.
Separate names with a comma.