The Jalopy Journal
Usually around 50 cars at the Thursday cruise nights at our Culvers in Manitowoc :cool:
Did you have to grind rod clearance on the old 400 block with 4" stroke? And you have a stroker pan on it?
There is alot of windage with that big...
If it has 4 corner idle screws there is also a screw to slightly open the seconsary blades at idle, it will lean out the the secondary idle...
Disconnect the exhaust pipe and see how it runs :rolleyes:
Wonder if these two ever went at it. :cool:[ATTACH]
Do you have a engine oil temp gauge, Hardblocked 1/2 full wondering what temp the oil gets to ?
Is the inner diameter of the rocker shaft holes a tight fit on the rocker studs, they may be loose enough to get
a little adjustment individually....
The older I get, The better I was :rolleyes:
Any N.O.S. plug wires ? ;)
Most stock Chevy distributers that I played with should have about 22 degrees of machanical movement, so at 4 degrees initial total timing all in...
Had a great time at the Fall Out, avitar got taken out 1st round of the pie crust session. :D
Have got to learn how to feather the gas pedal the...
I agree with Jim, Chevy Fast Orange for the 327 engine with a black interior, white would be hard to keep clean in a actual shop truck :oops:
No Skirts with gray 5 spoke Americans and blackwall tires
I think alot of gassers were built by Vets after they came back from Vietnam well into the 70s, I talked to the builder of a 67 Chevelle the drag...
I don't know much about Q-jets, Holley needle and seats come in a bunch of diffrent sizes for more flow, from .097 to a stainless .150 that...
All packed up and ready to leave, sugar mama not going so I packed Chilli and Beer in the truck camper.
Stop and say Hi to a fellow hamber
Changed my s.b.c. engines over to fully synthetic in the mid 90s, The next 3 years shortly after spring start ups. lost 2 flat tappid performance...
The 375 hp 396 was available, the right dealer could C.O.P.O. you a 427 in the early F body. The real early 427 Camaros were dealer installed ;)
Didn't see many of the the imitation convertable top roof line back in the day.
Could you take a picture of the timing gears ?
Yes, the small car shows in my area have been setting new record numbers of entries, seen a few new cars and think some of the stalled projects...
That will be twice as good, 2 to 1 safety factor :D:D:D
I did something wrong, got to click to expand my posts #132 and above #137 :oops:
Ha, maybe thats why we haven't heard from A.J. in a while. "Scatterd Hemi" pictures please. ;)
O.P. said he had a 200-R 4, that low 1st gear with 373 should light em up easy, ;) like Squirrl said try to get the timing all in before your...
I would see how it likes 34-36 degrees all in with vacuum advance disconnected..
Have a friend blip it up to 4000 and see what you have,then check...
This Saturday, put down that Honey do list and get your car ready. :D
Separate names with a comma.