The Jalopy Journal
Did you rule out the U-Joints? Engine off, transmission in neutral,
Move driveshaft up and down and side to side. If any loosness,
U-Joint going bad ?
Post #41 pictures are interesting. The rear door opens like a sedan delivery.
Most hearse/ambulance doors open the other way.
Fiberglass fenders? Have a separate ground wire?
Fresh paint? Have star washers?
Try a different flasher? Is it heavy duty?
Just a few thoughts to...
It's a 1935 Ford Passenger Car Grille.
I used a Pinto/Bobcat wagon roof. Turned it sideways.
Try to find one without a roof rack (no extra holes).
Thanks Jeff and Jenny for the party.
And thanks Mark for the pictures,
it was a pleasure to meet you.
I had a similar problem with a voltmeter gauge.
It ended up being a simple fix, a bad ground at
Thanks Eric......It was great to hear Steve's voice again.
You did the car the way he would have done.
A pic of me and the car. It was taken Saturday.
St. Paul Park Minnesota
My guess is a forklift.
[IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG]
A few more pictures.
[IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG]
Way to go Jeff!!!!
A few more pics....Enjoy
I'll be there with this.
It fit very well well on mine.
When I moved my Bridgeport, I used a tow truck. The type with the adjustable boom
and lower cradle. Lifted with the boom and placed it on the...
Spiker, You did a great job!!! Thanks
I believe it may have come from a Jeep. Mid 60's to early 70's???
Playboy stickers, Fog lights, Keystone Classic wheels, Aircraft lights, Pioneer super tuners, Prismatic stickers, Long whip CB antenna's.
Bent rim? Check the wheels while on the car. Your hub may be off center,
causing it to run like a clown car. Bad wheel bearings? Good luck,I hope...
WOW You guys are fast! THANKS
The air thing makes it all "click" now!
That's the info I needed.
I am going to put a new master cylinder in my car tonight.
My question is ...Do I have to prime the master cylinder?
Even if I'm going to bleed...
Has anybody used one with a 3 duece set up? Does it clear the front
oil filler tube,carb and thermostat housing? This is of course using the
Is it possible your PVC is right over a rocker arm (near the push rod end) sucking oil from it?
Separate names with a comma.