The Jalopy Journal
there is signs of blackened blow by on the passenger side of manifold junction with the intake.
will i have to move heater box to get at things?...
ordered gasket set and might as well rebuild carb on the flat 6, it is leaking a bit.
can anybody pm me on carb rebuild and jetting tips?
i have a flat 6 in my 53
it has a exhaust leak between the intake and exhaust heat riser
what is the correct fix
anybody have pics of the...
hey have not forgotten post ,i am pressure washing car today to get to all the under stuff
and will get pics out
geez i kinda like my red pedal,does anybody know anyone near atl that can help with conversion.
found this also
The Jeep/Dodge AX15 5-speed, the...
i just got off the phone with machine shop and my 340 will be complete by turkey run
i weigh the cost of everything and i already have money...
IT WAS A BOSCH UNIT and look like what i had minus the oil fitting
and had a machined surface on top
i pulled radiator and pump and here is picture of oval tube for people that never seen this like me,where do i buy tube? now that i am to this...
look for the sparkly eyes
tracked waterpump due in tomorrow
going to change the ten quart oil change also
original glove box lid sticker recommends
thanks guys that will be my morning
a gallon or 2? for vinegar 50/50 ? with water or straight
i still have original 6 ordered new waterpump
my car is running hot want to flush the whole system
it has the complete heatercore system in car...
i am going to post a couple of pics of underneath and show what they have done to this point before me,they used lowering blocks in rear and...
i had a 62 lancer before this
i like the slant six but hate the distributor placement
and will never deal with that pain again
somebody had to ask for pics:D
i think you mean the el camino swap
but heres mine
to install or pull do i remove front clip to expose engine or pull from top?
i have a 340 but it is a waste to put in anything but a period car
its a 71 block from a cuda and hard to find
the 360 are a dime a dozen and you...
it has 30k mileage and was running when pulled ,fellah put 360 in it
can i put a dodge 241 ram and tranny in my 53 plymouth cranbrook
the cranbrook has flat 6 with hydrive auto
and the dodge is a standard
here is another option a fella at car show offered a dodge 241 hemi with tranny
will it bolt in ? or totally different beast in plymouth chassis...
i tend to agree from what i read it has 4 cross members , using the a body 8.75 rear with 3.42s
and freshened up 360 with the 4speed auto
i miss read a relay paired wires wrong ,i guess it goes with blind in one eye
barely see out the other and not having sense to ask someone how to...
the durango is my personal suv of last 9 years its had is moments but cannot fault it,
most problem are owner originated and cannot blame truck...
i am pulling my flat6 and hy -drive this fall and looking for tips on dropping car on a 99 durango frame or
installing durango drivetrain in...
drove car tonite and whole system died it was about 9 pm and still parked somewhere,tried field switch horn relay,with another still no lights or...
,can you identify the switches ?
i am that close to done,cannot wait to drive this weekend
i am rewiring my car and the trans has a switch facing the side and one facing the rear axle .
is one for back up lamp and the other for...
ok did that taking break from under dash as we type
thank you deano,
so do i move the ignition connection to the left terminal on ammeter as you would look at dash, and will that solve the issue?...
Separate names with a comma.