The Jalopy Journal
If you put an 8ba in a ‘48 and earlier car and want to keep your anti chatter rods you will need these adapters for the 8ba block. If I remember...
Thanks, been a long in progress build. Plan to start moving a lot faster now. Plan is to have done by summer ‘22
Damn, good eye. Yes, they are the same knobs. However I had to shorten them and reduce the diameter of the bases to work with the bezels and set...
1960s VW knobs with SoCal bezels[ATTACH]
Sincere condolences. Stay strong.
My son lived on the Miami side of Florida and I lived on the Gulf side, that meant we had maybe 2 weekends a month to work on the A, which in turn...
1936, for sure one of the nicest.
Conrad, I am running ‘37-39 spindles (#78 cast numbers) and ‘37-39 drums (date code H107) on my ‘36. Sent Joe the axle and spindles for a 4” drop...
With a/c vents open[ATTACH] [ATTACH] with a/c vents retracted
Just found this thread also. Wow, what a build! True old school rodding at its best.
Oops, from the drivers side[ATTACH]
See if these help any with visualizing the clocked stand base. New production Slingshot. [ATTACH][ATTACH][ATTACH][ATTACH]
Thanks. The entire drive train was actually sold before we even pulled it.
All 4 wheels are original wide fives. I had to use an adapter for the rear bolt pattern to wide five whee
Don’t know. Car was painted in the 90s. I tried to track it down but didn’t have any luck
After 7+ years of varying changes our ‘36 has reached its final form. 3 years ago my dad and I decided to make a major change to our coupe. For...
This is the idler pulley assembly (3829192) used on 63-65 Corvette HiPo 327s. It was bought new and bolted on the project engine during mockup,...
Billet Specialties 90120 SB/BB Chevy straight thermostat housing. New, but opened package. With o ring and mounting hardware. I...
New Vintage Air 389804 Streamlined 4 way black anodized bulkhead fitting. $35+8 shipping
[ATTACH] [ATTACH] [ATTACH] SOLD,SOLDThis unit came custom mounted on a one-off radiator setup ordered from Brassworks. During the build we made...
Your stretching my ability on this one. I am unsure that you would have clearance to access the bearing with the oil pump gear there.
Yes, If that’s the case.
Good possibility that whoever installed rear cam bearing went too far aft. Pushrod will not contact cam.
Separate names with a comma.