The Jalopy Journal
How would a small blemich be repaired? Is it possible to "blend" in a section, Say 6" by 6" repair to a scuff, rust repair or whatever?
In 1969 ,late winter i was workig for Don Yenko Chevrolet, it was so cold the cars on the transportor would not start! it was below 15 degrees and...
Let's see, a Nambla of 142, quite impressive!
People are always impressed by "high" I.Q. internet scores, shows validation to upper "intelligent...
Hell, your Dad had to tow in a full tilt race car to beat a guys' daily driver?
The dude must have been laughing so hard seeing that...
I was wondering, how did Squirrel perform at the HAMB Drags?
He sure seems to know his nuts on his Chevies, how did he run against the drag...
Holley carb - check float level, on a Street Avenger there are sintered bronze filters.
These can not be cleaned, only replaced.
I saved this creepy pic.
A ghost to your left side.
Thanks for not taking pictures of your toes.
You should get about "half-pedal" if a failure occurs, if plumbing is correct.
The air appears to flow front to rear, I always thought because of the way it faces.
These guys show where the air intake is located....
Is it wise to post up someone's tag , without permission?
We have had some terrible misfortune here lately.
The GM fan on an alternator is an exhaust fan. Air flows from the rear of alt. to the front.
Just some information I picked up the other day...
What header paint did you use? How is it holding up?
I like the leaf spring set up, hows does it ride?
17 more questions to go!
Thanks Don and Norm, the ridge will be removed for sure. Our bore gauges disappeared when another mechanic was overhauling his engine.
Thank you, Ray, and all, for the prompt reply!
I gently removed the pistons after stamping the caps and pushing them out by hand. Wasn't too...
This is my first new post since I have been a member. I am an avid searcher!
I cannot seem to reach a definitive answer although I know the...
So if you are hitting the by-pass pressure you are wasting energy?
My experience with a Melling HV pump on a hand built 355 was high blow off...
I like to pull a bottom bowl screw off the carb and catch the fuel in a dixie cup.
Seems to be the quickest way to empty the bowls and the motor...
Flip it, trade it.
Use it to get something you really want.
Very good information on this thread! I found it on a SEARCH, Dick Spadaro is truly an asset to the HAMB. A good running front end makes all the...
Dig your tag!
Liquid dish soap, like Dawn.
Very Sorry to hear this, eyes and ears open in Daytona and Ormond Beach.
The Dreamcruise is coming this weekend, will be there, too.
I put a Melling MTC-1 cam in a 355 SBC, it helps to promote the dynamic compression ratio. Oddly enough it was the same as an Edelbrock Performer...
A little paint won't hurt, most people want a good looking engine on the stand so their buddies will "ohh and ahh" while it sits there for God...
Well, well, well.
Mr. Deep Pockets has spoken!
Please post pics when you receive it.
Not a chance.
Separate names with a comma.