The Jalopy Journal
I've seen gasoline and a burning rag do the job..
I have a 57 Chevy with a LT engine.The idle speed is 12-1300 rpm. I hope someone could tell me how to slow it down. Thanks for any help.
I built a set of fenderwell headers on a 55 chevy (C/gas) all out of left over exhaust and tailpipes about 55 years ago. I know some of my welds...
[ATTACH] [ATTACH] 1923 Model T Roadster Pickup
NEW Chevy 350 CU. IN. 350 HP Crate Engine
ALL New Engine Accessories. Starter, Alternator, Water...
A friend of mine ( Phil Anderson ) hand carved the pattern from a piece of pine 2 x 8.about 55 years ago. We cast the plaques in the school...
Using plastic fuel lines on an engine is about as safe as using a plastic fuel filter.close to the engine.
A lot us would never have seen this show. Thank you.
Good on you bud, I"m glade your doing things the way YOU want. Everybodys got THAT opinion.
On the 32 I welded backing plates inside of the grill shell. drilled mounting holes at the height I wanted the lights.
mounted the light housings...
here's my 32.[ATTACH]
AGAIN!!!!!. Can some one tell me the proper way to measure for a new drive shaft?
Thanks for any help.
When I was about 16 ( 50 years ago ) I had a Forty Ford. I side stepped the clutch and the bottom of the transmission blew out on the road. Lesson...
Which 4 cylinder Mercruser engine is best for a lightweight street rod?
23 ROADSTER 350 chevy crate engine 9" rear coil over , 350 trans, lokar shifter,, and lots more.
Fast and fun OR BEST OFFER.
IS IT ENAMEL OVER LACQUER, OR LACQUER OVER ENAMEL????
I HAVE THIS CRS DISEASE.
I have a chance to pick up a aluminum engine out of a boat. I"m wondering about rotation, if it"s worth fiddlin with, where to get parts, etc.+...
where can i get info and where to get parts for hotrodding a chevy "6"
I used a Van Norman crank grinder in 1961 on an old Dodge truck. Also some the old brake riveters
here'[ATTACH] s mine for sale
Here's one I built.Gave it to my son.
took a ride...
Gettin a puff of smoke when I start my truck. I suspect valve seals. I'm
wondering how big a job this is.
i have a 1998 dodge with a 360 engine. Is it much of a job to replace the valve guide seals?
Separate names with a comma.