The Jalopy Journal
Hey guys, I just purchased a 3.5gal moon tank for my A. I'd like to see some of the ways you guys have them mounted out front. DAVE
AOD does not have a lock up.
This car belongs to Chadly Johnson. I sold him this car in bone stock condition a few yrs ago. Hes done a great job on it. DAVE
I have an extra Hurst (speedway) style if you need it. $50.00 + shipping. DAVE
Check it in manual low, if its good its usually in the direct clutch
Check the 2-3 shift, if good, its a problem in the low rev clutch
36roadster, I have step by step videos for rebuilding th350s. I can loan you one if you pay the postage to get it to you & back. Call me if you...
OOPS, I read it wromg. If you have a later style 700R4 (87 up) w/ an aux valve body you must use the tube. DAVE
No, plug it off at the pump.DAVE
OOPS, I meant 89-92
On another note, you can use an earlier valve body & separator plate on the 89-93. However, it must be from an 87-88 w/ aux valve body. If you...
If you have a valve body with a lock up valve train, you DONT NEED ANY WIRING to make lock up work. All valve bodys from 82-87 had the lock up...
onlychevrolets is exactly right!! I have posted this several times about NOT needing any wiring to make lock up work on a 82-88 700R4. If you want...
I bought one of the old GSTA dragsters last summer. Its just sitting in my shop taking up space right now. My daughter wanted to race it, but has...
If you're using a sbc, I'm using a bellhousing, hyd slave & master off a 84 ish camaro. DAVE
Talk to Plowboy, hes running 6x2 on his bubbletop w/ a th400. Dave
We normally add a vent on the tailhousing during rebuilding. It has always been a problem on the cast glides. We drill the tailhousing on the...
I had a 64 Falcon sprint back in about 67-68 that I put a 427-425HP in. Used an econoline axle also. Raced it until I got creamed by a new 68 Road...
You dont need wiring on a 82-88 700R4. It can be done thru the hydraulics. Dave
okiedokie, theres at least 20 different length modulator pins. But what do I know?
Does this happen under hard acceleration? Does it shift on time or a bit early? It could be that your modulator pin is too short. DAVE
PS, We make step by step videos for this trans if you need to use one. DAVE
Are you using the wave plate in the direct clutch? If you are, try to get it close to.030 clearance. W/ no wave plate, best rule of thumb is .010...
Depending on the year, you dont need ANY wiring to make lock up work. We do this everyday for our performance transmissions. It needs to be a...
Most reputable trans shops have a converter flusher. I'd take it to them or do as RAY With said. DAVE
You dont need it. Its only there to protect the trans if the cable comes unhooked or breaks. DAVE
oops, its a 7/16 head bolt. DAVE
Cable is probably stretched. But the cable is adjustable. Theres a wheel looking thing right where the cable goes into the trans. Try taking the...
Snap on #AT-52 Front servo guage Snap on# AT-54 Rear Servo guage
Flatoz, I have the tools you are looking for. Let me know how I can help. DAVE
Separate names with a comma.