The Jalopy Journal
Traction bar, but similar
[ATTACH] flake? Not mine
After a couple decades the rest of the windshield is probably sandblasted so a new one will seem incredible
Here's instagram "Until further notice I will be on a break from axles, so I can focus on some health issues that need addressed. I apologize for...
Even though same compression height 230 has 1/4" more stroke so high comp is now very high compression.
not a streetable compression
I like the ones with an eyebrow over the gauges
There are some that share roofline like 1950 Hudson [IMG]
competition coupe style with a reasonable wheelbase and rear tires inside body and a big rake which might necessitate a roadster or open top coupe...
I milled the M/T off an Olds set and added an Oldsmobile body script with a couple speed nuts and some epoxy to the banner section
502 BBC in fleet trucks
There is a new maker of Holley type carbs from a couple years ago fstcarb.com. Also Slayer has low priced Holleys
[IMG] I was looking at tri-groove nuts for my hoodless build with a dragster scoop.
I did a tilt column with a dune buggy tilt column piece for 3/4" shaft welded to a cowl roll bar and an agricultural u joint at the pivot point....
Longest trailer springs are 30" with about 4" of arch
Same people sell auto springs so might...
Seems like cutting Anglia doors to Prefect width might be the better solution.
you might drop a PM to https://www.jalopyjournal.com/forum/threads/project-prefect-help-info-opinions-needed.242389/
Hot rod heads for the Rover https://roverv8wildcatheads.home.blog/
and intakes http://www.johnealesroverv8.co.uk/index.html
Spirit has a 36" bed. Put frame halfway up and use a Mustang tank as the floor.
What engine? OEM now offering permanent magnet starters so junkyard may be the deal.
no. It was linked in an old HAMB post
Let's shift a bit. If it's a daily driver you want to burn regular. If it's a toy, you can do premium. I've been through the water injection,...
you'll need ~25cc dish for pump gas
you'll probably lose the fuel pump lobe
I'd make a couple 3/16" plates to fit between block and mounts with 2 sets of holes 3/4" apart. Same for trans. Probably have to grind mount for...
When the Navy came to GA Tech recruiting 50 yrs ago they said you would work on Diego Garcia but could go to the mainland once a month. That...
Separate names with a comma.