The Jalopy Journal
You really never know,last year I took a 60 wagon from the graveyard that looked worse than that and put a few fresh parts on it and it ran like a...
I've used this setup in the past with good results
Mine has a good powerd 350 with a 10bolt posi rearend attached with factory leafs, seems ok,but I am going to swap them out for a 4 link in the...
Gonna be there!
Like I said before I personally don't care for the width of the crown vic clips, I did mine with a early 90s Chevy halfton clip, perfect width and...
Not many cheap options, I say MustangII or clip, no crown vic swap, too wide!!
I already have plans to go to a show down on the coast that weekend, it's too bad cause the road rocket rumble is badass
the last time I took my buddys word that this guy did amazing work, the guy showed up and took forever to do very little striping, and it didn't...
Looking to get some striping done soon, I can travel, or u can come out to the shop
A little clean up, steering lined out,
302 motor in the Chevy clip
I've never heard of it either, but I had one the was going to scrap, and it also had drop spindles on it, and lots of newer parts, tie rods,ball...
Ditch the crown vic clip and weld in a early 90s Chevy truck clip, fairly easy install, Lays out good with factory wheels, also parts are cheap...
Here is a better pic of what he is after, notice how the bushings are mounted parallel so that they match the lowers, it's just a slight variation...
Were drove down from Indiana, defiantly a good time!! What was the total car count end up at?
That is badddddd!!!
Thanks for the pointers,the Camaro clip wouldnt have been my choice for a clip,but im sure I will figure it all out when the time comes :-)
I got the beast running really good now,but the suspension is so bad that u really cant drive it far, someone heated the front coils with a...
My harbor freight jack has outlasted two brand new craftsmans!!:eek:
That turned out nice!! I like the rear tub work too!!
I always mark the top and bottom spots on removal,it cant get any easier, It only goes in two ways, so your going to be good,or out by 180°, or if...
Im running a c4 behind my 302, I wouldnt mind a aod, but a c6 is not a option at all
I like it, priced really nice too
I wish I would have snapped pics of some of the crap I came across over the years, I have seen some bad bad work, here my old Datsun truck that...
Lol, he is really cheap, he works for candy!!
Good deal,I always try to get the biggest I can, when I built my Datsun everyone said that I had to run a 5" bag or mount a big bag to the upper a...
Separate names with a comma.