The Jalopy Journal
is it the same width as a 35-40
do the spring pad positions land perfect for 35-40 rails
does it take 40 ford back plats and 39 wide 5...
will the wheels rub the fenders
engine is 40 over, with some wear - 4.040 plus wear
does this ring gap 'look like' stock 4.000 rings
to hand? how wide is it?
Perch width 34”, 1935-40 Ford, Use with axle
au- 2107 n 34'' perch width
is this spring 35 inch wide
hello can you take a 1990 305 roller sbc and
1. fit 283 small valve heads with staggered valve covers - no accessory drillings - what is the max...
so the 1998-2004 c5 vette master fits the dual can 7'' booster as its gm, plus is 1'' bore
when fitted underfloor - cut floor so plastic...
Hello, need someone to check my homework.
1. buy a 87 - 91 roller cam 305 engine
2. remove heads and fit 80-85 305 heads -early intake 80-85 -...
68 Camaro upper collar
Grant adaptor top
The lower bit is the earlier column collar top
did they ever make deep dropped forged steering arms in the right hand drive
if for example I had a stock 40 wishbone, kept it unsplit and bent the perch pin mounting inwards 2 inches per side, am I going to be in trouble...
so, I have a 37-40 frame
40 wishbone - unsplit 2.25 boss
can I simply use the 40 wishbone 38.5 perch - with its 2 1/4 boss, with an aftermarket...
I take it high current draw of horn has to go across a relay
its switched from single feed wire to contact ring , onto the button
is the steel thicker in a pick up chassis
is it due to the car body offering some rigidity?
i.e. I should not EVEN contemplate using a car frame...
I take it they are not supposed to sit flat[ATTACH]
does a 35 car glass lense
are they the same for right and left hand driving?
I cannot see a specific pattern
the first time it happened I thought a loose ember landed on the Teflon coating and ignited it
it happened again today
why does it happen??...
the 2000 v6 camaro firebird pressure plate and friction disc @ 26 splines and 1 1/8 girth, bolt straight onto a 52 8ba...
Anyone ise one in a rod.
Would it be easier to modify an older 40s style hadees unit with an electric matrix
whats to stop you levering the tabs up and swapping the twin feed plastick tank onto another one.
can get 22mm 3mm wall easily on ebay cds seamless
11/16 sae wants a 5/8ths bore?
22mm minus 6 is 16mm bore
5/8ths is 15.87mm
I have already...
1938 ford pick up
Pressed steel bell house
1971 mustang 9 inch with 56.5 maverick sjafts.
Econo front brakes
do I simply remove the tone ring from the gm out-put shaft and swap it with a speedo drive gear
then fit a th 350 drive housing with gear
Helli i have a 36 to 36 spline and the length is good. Cant see them on the borgeson site. Is it ok to use a vibration damper with a single...
1310 each end
is it the camaro v8 t5 trans
i.e. does it...
Is there an car parts dealer in the usa, that offers a service where
they physically open the parts box, take a photo, send you the photo of the...
hello, did the 37 tube axle have its own wishbone
or did it run a 37 wishbone
the I beam pictured is 1939 does it needs 39 bone
Separate names with a comma.