The Jalopy Journal
Yep HRP your a rock star now!
For tapping there's a Manual Tap Driver but you've got an idea I might just try!
69fury the 5-1/8" bellhousing bore should be the alignment and it's a snug fit
If I had a lathe there would be no question on the accuracy, but...
Question...is there a better tool to help align the die to the round stock or the other end of the bolt. My current setup is causing it to...
I think Rustem is converting to an open drive-shaft from the old torque tube
Hmmm ..somehow you just started this thread
do you have "NoScript" running ?(firefox)...that will block it
Norseman ... Lost inside the Andrea Doria
Yep a HotRod Norton!
Is this a Model 18?
The '50 should be running 1/4" lines , I would remove the rear supply line to that tee on the right frame rail and plug it
Then run a parallel...
Even though the tip's 1/2" away from the work, sometimes the wire flips to the side off the beaten path, like veering off course, It's just...
I've read more than once - suck with a screen - push with paper
some of my briggs&s engines ran fine with reused head gaskets after painting with hi temp silver
since you have new parts still coming in -...
Looks like I'm not the only one... chalk this one up
How about Radnor wire (Airgas)
It unreels underhand O___ I'm thinking it's defective - but there must be a way to rewind and straighten at the same time
Any thoughts to correct this situation -- This .024" wire is spiraling out of the gun , it's funny ...when welding, not only do you have to...
...gotta crack the tank valve slowly,the regulator probably blew the diaphragm and can be rebuilt
as for hose , you can use a length of oxygen...
Maybe not, dirty connections, broken wire strands could also be a culprit
Quite possible the contacts in the solenoid spot welded themselves, I think it happens from low voltage
If it's the std Delco solenoid there's a...
I set sbc lash while running with 1/8 turn increments (use those deflectors - Less clean up)
Wypall waterless hand wipes to remove oil and dirt stains from carpets
Try this for corroded steel screws in aluminum
leave acetylene soot near the screw boss - bring to neutral flame to burn off soot
Is that a brake line going above the master? (could be an air pocket issue)
The old way to bench bleed was with return hoses to reservoir - I now...
If you try that, look how motorcycle petcock drains are assembled - usually with a standpipe strainer -- have you tried a boat tank primer bulb ?
I'm biased towards Chevy's, but that engine dress up crap's gotta go
Body Styles for Passenger Cars
<table border="0" cellpadding="0"> <tbody><tr><td>Des.</td> <td>Style...
Separate names with a comma.