The Jalopy Journal
Even though it`s getting more difficult to do a lot of what I enjoy doing.My project is a 48 f1 Ford roadster pu with a 440 -tq flite and 9 inch...
Find a good quality small right angle drill ,sander, air drive and some 4 inch buffing pads and arbor.Easy to handle and does a great job.:D
Unless you are fluent in flatheads and have a ck book with a lot of big numbers in the balance colum.I recommend the sbc and a 4bbl of your...
Make sure you are getting a full 12 volts at the distributor.Voltage drops as they get hot. hope it helps.:D
Hamb name is Too ManyTo Count :D
You are on the wrong track.Builders Hamb name is "Too many to count":D
Dual duce intake and carbs for 34 Ford 85 hp
All I can contribute is some standard shift and automatic transmissions use different starter drives.:D
"Look up" too many to count" Last I seen of it was an early 50`s suburban with a 500 Caddy :D
If it has a vacuum modulator,it may have failed or the hose has come off.:D
Make sure the
secondaries are closing all the way.:D
Now that you have it out try dry ice on the crank and heat the balancer with a hair drier.:D
iF YOU OR SOMEONE ELSE IS GOOD WITH A MIG,SLOWLY BUILD UP A PILE OF WELD UNTILL ITSTICKS BEYOND THE CRANK SNOUT.After it cools take a pair of...
Tip may be worn .You might need to remove the wire all the way from the spool.Liner may be a suspect as well.:D
Go to fordifacation.com makes ID a snap.:D
I believe this repair would be a viable option.Watch the video and judge for your self.:D
CK your brake pedal geometry.Sounds like you need more travel at the pushrod.I have ran into this problem more than once.:D
For reference only,my 48 had a spring clip that slide in a groove on the lock cyl.Access was thru the inside door panel. 39`s may be different...
Welcome to the HAMB and rodding,sounds like my one time problem,too many projects and not enough MONEY .No,I didn`t find a bunch of money.I paired...
Cant help myself,Buy the shoes,the box is free.:rolleyes:
SBC with 30-30 Duntov from idle to 8 grand or so.Forgot, open headers.:D
I have been on and enjoyed most of my shakedown runs,in fact I just did one today.Never had one strand me ,but I did have to clean a fuel filter...
Shouldn`t the valves be rotating if the geometry is correct?:confused:
Welcome from Carrollton.:D
This is a very likely suspect,it`s the only thing you really changed.:D
I dont remember the name of the car but I had a bubbletop 58 Chevy parked in my garage overnite.It was supposed to have been built by George...
Replacement parts are available,and parts carbs are cheap.I suggest downloading "Servicing the carter aluminum four barrel carburetor" at...
Make sure you are getting a full 12 volts at the coil when cranking,HEI`s are funny that way.
I recommend the 135 220 model,I`ve had good luck with mine for 15years now. Practice a lot and watch out for cold welds.Penetration is :good if...
Separate names with a comma.