The Jalopy Journal
Do you see a squirt from the accelerator pump nozzle
Modified these vice grips of an extended reach.
Why can't ladder bars be mounted inside the springs? May be a little narrow but...
How about a single torque arm.
If you tape it off, look for some fin line tape the correct width. Could save some time.
Around here we eat squirrel. Mice and rats are for the predator's.
See there you go :mad:, :Dnow I'm going to have to have one. :)
What are you putting one on?
For the chevy engines try these guys. https://www.dbelectrical.com/starters/
The factory starters from the later...
Put some clay in the housing to check for contact problems.
All the info you could use. https://fabcraftmetalworks.com/
With a crush sleeve style pinion bearing preload system if reusing the crush sleeve there is no torque spec. If you try to go to a torque spec of...
It kinda does :D
Sorry it wasn't a good outing, you'll get it.
I use the Berryman chem-dip in a 5 gal bucket. 20 to 25 minutes agitate a time or two, flip the parts then another 20 to 25 minutes with the...
You had to let it ring once or was it twice hang up and then call back.
When you check it you need to have the transmission in neutral so there is no load on the drivetrain.
You got 8 grand burning a hole in your packet? :D
If it makes a proper ark, that is all that matters.
Get were your good when comfortable, then work on getting good when your uncomfortable. :D
What kind of welder are you playing with? Looks like your off to a good start.
I would prefer to have idle on all three because I would have the linkage one to one.
I use the spring traps with no bate, just set them it their pathways, it's more sporting. :D
Looks like your hard work payed off, nice job.
What's the story on this car?
Does this new distributor have a vacuum advance?
I just measured a 47 that is out of a truck and it's 25 inches.
I think it would be hard to get a accurate reading with the bushing mount system...
Can't you still get a point's distributor for one of those? :)
What ever you get, have it curved for your engine. ;)
Separate names with a comma.