The Jalopy Journal
I thought I'd like to see what ever happened to a 34 3W I built back then and if the current owner would like info only I have about the car....
I have the VIN from a car I had back in the 60's and would like to search for the current owner. Is there a way to do this without getting...
there aren't any other numbers that I'm aware of.
So the picture didn't post, will try again but it is a stock 2X4 manifold setup I think from 1964.
I have this setup for a 427 and need to know if the carbs I have are the right ones. They are list 9776 / 3361. You Ford experts know if...
my first car, taken summer[ATTACH] [ATTACH] 1959
If the one on the right sneezed that bottom would disappear altogether.
couple more that were requested. [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
34 Ford steel 3W - 6 inch chop - 1 1/2 inch channel - 8Ba +.040, mild cam, Navarro Heads & 2 carb manifold - 4" Merc crank - Magneto ignition -...
I love the idea of the 4L60E trans. I'll be going that way, Thanks a lot for a great article.
I don't know squat about 390-428 FE motors but thinking about running one. Can an AOD trans be adapted to them? Are there any other overdrive...
[ATTACH] The hood on my 34 is a stock original, only mod is the louvers.
As to the chop, The issue of course is visibility. I posted this pic a...
Some think I chopped my 34 too much. Interestingly enough, the only person that has to like it is ME.
If you are referring to the wood B pillar and above door wood header, I used The Wood n car
2345 Walnut Ave.
Signal Hill, Calif. 90755
All good info, thanks Steve. See you at the Goodguys.
Just removed the pulley. Reads C54? can't read the last number. That help?
Thanks RmK57 very good info
[ATTACH] [ATTACH] [ATTACH]
The block is clean, no grease or dirt and no cast or stamped numbers anywhere. The bolts for the bellhousing are 7/16. I pulled a valve cove and...
Three bolts on the pully. Starter is off not the valve covers. I'll load up a picture tomorrow if that helps.
I picked up a small block Ford motor that I have no idea what it is. There are no numbers or castings on the block anywhere. The water pump bolt...
I guess I had it over priced. Have it for sale locally for $34,500 Want $32,000
There are guy's here that would make a car out of that!
My car [ATTACH] as it is today. Yours is incredible!
Separate names with a comma.