The Jalopy Journal
[ATTACH] the pictures of that manifold i see online show its drilled for bolth patterns. have you set a holley on it to see if it will seal up
Did you check the valve lash on that cylinder while the intake was off
I would bet that summit packaged it well enough for their part of the trip
Why would you blame them it has been through what 4 shippers and more miles on a boat than most cars on here are run in a year or two
For most of us the fuel we use today is not what our carbs and distributors where set up for when they were built 5 to 10% corn makes a...
so it is summit and gm's fault that it filled with water on its BOAT ride to you. Did you contact the shipper they would be the ones that mis...
sorry to say but that looks like shipping damage to me. how was it shipped and was it insured
never heard of options for 1904 power valves.
There must be more to this one!
Glad to hear he is ok! was hopping to hear that thanks
Did you have to pull the intake or support the engine so you can remove the engine mount and lift the engine? If not how bad was it realy?
That looks the same as the ones for a
Dakota Digital - Digital Instrumentation and Accessories
The red one is 61 early 62 and the other is late 62 until the style change for 64
Call the local cops and ask for help getting your truck and see where it goes.
All the floor pans I have seen for this truck leave a 3/4 or so gap between the left and right panel if you change bolth
do a compression test just because the rockers are not adjustable dont mean it dont need to be right
The caliper brackets look to take 68 to 71 mustang calibers and hard ware. The rubber bushings and anti rattle clips do not belong to any gm...
dougs fit hipo manifolds dont
same as the lines i posted if they are for a falcon mustang lines would bolt right up
[ATTACH] Ok I dont get it why the fancy adapter are you that atached to the hard line that is there that you cannot bend a new one to reach either...
Ok do I have this right the engine was rerung and put in your car you and you lost a cam lobe. Then you drained the oil changed the filter and...
how hard did the old studs come out i have done lots of that style stud and only ever seen heads crack trying to remove old studs with lots of...
The only one to tell the mods off! got the one thread i went to every time closed
Whoever just deleted my last post on finishing up the paint on that truck, you better go back and delete all of the other posts about the same...
the 351 went to 50 oz in 84 or so so you need to know what 351 you have
some thing like this
Whoever just deleted my last post on finishing up the paint on that truck, you better go back and delete all of the other...
You could mesure the spindle angle by mounting the hub face vertical and mesuring the angle of the king pin
If the cam gear is broken the distributor would not spin with the crank
At swaps I get sick of asking for a price and getting "What you give me for it" If I have to be the sellier and the buyer I am going to give...
Separate names with a comma.