The Jalopy Journal
Have triple A now. But take my Ridged brand battery powered impact. Just in case. At 75
I can jack the car up. But getting the lug nuts loose is a...
I've drilled the original knob out and put a collar inside with JB weld. Making sure the screw is lined up with the screw hole. Add the correct...
Did some Murray bodies have the vent.
Had TCI on my old coupe. Had to replace the fronts once but never had to do the rear.
The vans had shorter shift handles. Looked better using a smaller wheel. The turn signal usually failed because of broken return springs in the...
I twisted my shaft enough to make the handle level.
Now several years I tried this on a coupe. The original gutters had a retainer. You nailed it in place. Then fitted the drip rail to it. These...
What he said. Never a problem with one of these.
Think how good this will look to ya when you get your eye fixed.
Looks top notch from Texas!,
Did you try the Ford Barn for a good used one?
You will be very happy with the eye repair. I put mine off several years because I am a coward when it come to Drs. If you have the funds for the...
PM me so I can get your email. I might have an answer. I can easily send you pictures.
Broke a 12-24 in the roadster door today. Liked only three turns to finish. Had the lube there but didn't use it. Last hole to tap!
Their is a book that shows the Chevrolet paint scems. I can't remember which one.
Last car I hired out to wire. They were hiding it in the tube core support and stuff. No way to ever repair it if need be. I quit and walked. I...
If it has an R in the vin it could have my finger prints on it. Worked in the local factory that year.
Wondering why you want to do the EZ steer over your Ford box? Put a 53-6 box in a model A and it worked like a dream. Rebuilt like new.
Might run into an issue running the stock fuel pump. Real 57 283 has no side mount boss I think
They are working at the state level in a limited number. Local level is even less. You can't get new license right now. Unless you are doing mail...
How about repop for the earlier corvettes.
Shouldn't their be a resistor in the heater duct. This gives you your three speeds
The local car factory put wo in every car on the line.
Look up catfish here on the Hamb. He does a fine job on them. If you can't find him let me know and I'll PM his number. In St. Louis
posting for a friend. He bought a car with this on it running. Carb is way to big for 350 chev with a cam. Can't determine if is a 800 are 900...
Cooling components fit the Walker real well. Only needs four small sheet metal screws. My old coupe had one for years. As stated above you need a...
Bench bleeding is most important. Takes more than just a couple of minutes.
Separate names with a comma.